Freescale Semiconductor
Technical Data
Document Number: MC33886
Rev 9.0, 4/2011
5.0 A H-Bridge
The 33886 is a monolithic H-Bridge ideal for fractional horsepower
DC-motor and bi-directional thrust solenoid control. The IC
incorporates internal control logic, charge pump, gate drive, and low
R
DS(ON)
MOSFET output circuitry. The 33886 is able to control
continuous inductive DC load currents up to 5.0 A. Output loads can
be pulse width modulated (PWM-ed) at frequencies up to 10 kHz.
A Fault Status output reports under-voltage, short-circuit, and
over-temperature conditions. Two independent inputs control the two
half-bridge totem-pole outputs. Two disable inputs force the H-Bridge
outputs to tri-state (exhibit high-impedance).
The 33886 is parametrically specified over a temperature range of
-40
°C
≤
T
A
≤
125
°C,
5.0 V
≤
V+
≤
28 V. The IC can also be operated
up to 40 V with derating of the specifications. The IC is available in a
surface mount power package with exposed pad for heatsinking.
Features
• 5.0 V to 40 V Continuous Operation
• 120 mΩ R
DS(ON)
H-Bridge MOSFETs
• TTL / CMOS Compatible Inputs
• PWM Frequencies up to 10 kHz
• Active Current Limiting via Internal Constant OFF-Time PWM (with
Temperature-Dependent Threshold Reduction)
• Output Short-circuit Protection
• Under-voltage Shutdown
• Fault Status Reporting
33886
H-BRIDGE
VW SUFFIX (PB-FREE)
98ASH70702A
20-PIN HSOP
ORDERING INFORMATION
Device
MC33886PVW/R2
Temperature
Range (T
A
)
- 40 to 125 °C
Package
20 HSOP
5.0 V
CCP
33886
V+
OUT1
V+
MCU
IN
FS
Motor
IN1
IN2
D1
D2
OUT2
PGND
GND
OUT
OUT
OUT
OUT
Figure 1. 33886 Simplified Application Diagram
Freescale Semiconductor, Inc. reserves the right to change the detail specifications,
as may be required, to permit improvements in the design of its products.
© Freescale Semiconductor, Inc., 2007 - 2011. All rights reserved.