F81867
FAN2_
4
3
R/W
R/W
Set 1 will enable the interpolation of the fan expect table.
5VSB
5VSB
1
1
INTERPOLATION_EN
This register controls the FAN2 duty movement when temperature over
highest boundary.
0: The FAN2 duty will increases with the slope selected by
FAN2_RATE_SEL register.
FAN2_JUMP_
HIGH_EN
1: The FAN2 duty will directly jumps to the value of SEC1SPEED2
register.
This bit only activates in duty mode.
This register controls the FAN2 duty movement when temperature under
(highest boundary – hysteresis).
0: The FAN2 duty will decreases with the slope selected by
FAN2_RATE_SEL register.
FAN2_JUMP_
LOW_EN
2
R/W
5VSB
1
1: The FAN2 duty will directly jumps to the value of SEC2SPEED2
register.
This bit only activates in duty mode.
This registers companying with FAN2_TEMP_SEL_DIG select the
temperature source for controlling FAN2. The following value is
comprised by {FAN2_TEMP_SEL_DIG, FAN2_TEMP_SEL}
000: fan2 follows PECI temperature (CR7Eh)
001: fan2 follows temperature 1 (CR72h).
010: fan2 follows temperature 2 (CR74h).
011: fan2 follows temperature 0 (CR70h).
100: fan2 follows IBEX/TSI CPU temperature (CR7Ah)
101: fan2 follows IBEX PCH temperature (CR7Bh).
110: fan2 follows IBEX MCH temperature (CR7Ch).
111: fan2 follows IBEX maximum temperature (CR7Dh).
Otherwise: reserved.
1-0
FAN2_TEMP_SEL
R/W
5VSB
10
C. FAN3 Index C0h- CFh
Address
Attribute
Reset
3VCC
3VCC
Default Value
8’h0F
Description
FAN3 count reading (MSB). At the moment of reading this register,
the LSB will be latched. This will prevent from data updating when
reading. To read the fan count correctly, read MSB first and followed
read the LSB.
C0h
RO
C1h
RO
8’hff
FAN3 count reading (LSB).
82
Dec, 2011
V0.12P