FTR-1621-XX WDM GBIC
Product Specification - March 2002
Finisar
II.
Electrical Power Interface
Finisar FTR-1621-XX WDM GBIC modules have a power supply voltage range of
4.75V to 5.25V as described in Table 2.
Electrical Power Interface
Parameter
Supply Current
Maximum Voltage
Surge Current
Input Voltage
Power Supply Rejection
Symbol
I
s
V
max
I
surge
V
cc
PSR
4.75
100
5.00
Min
Typ
280
Max
350
6
400
5.25
Units
mA
V
mA
V
mV
Referenced to GND
See Note 1. Peak to Peak
Notes/Conditions
Table 2. Electrical power interface
Note 1: Receiver sensitivity is compliant with power supply sinusoidal of 20 Hz to 1.5Mhz up to
specified value applied through the recommended power supply filtering network
III. Low Speed Signals
RX_LOS, TX_DISABLE, and TX_FAULT are TTL signals as described in Table 3.
MOD_DEF(1) (SCL) and MOD_DEF(2) (SDA) are open drain CMOS signals (see
section VI, “Serial Communication Protocol”). Both MOD_DEF(1) and MOD_DEF(2)
must be pulled up to host_Vcc. Note – MOD_DEF(0) is grounded inside the GBIC to
indicate the correct mode of operation.
For more detailed information, see sections 5.3.1 – 5.3.8 in the GBIC Specification Rev.
5.4
1
.
Low Speed Signals, Electronic
Characteristics
Parameter
GBIC Output LOW
GBIC Output HIGH
GBIC Input LOW
Symbol
V
OL
Units Notes/Conditions
V
4.7k to 10k pull-up to host_Vcc,
measured at host side of connector
V
OH
host_Vcc - host_Vcc +
V
4.7k to 10k pull-up to host_Vcc,
0.5
0.3
measured at host side of connector
V
IL
0
0.8
V
4.7k to 10k pull-up to Vcc,
measured at GBIC side of
connector
V
IH
2
Vcc + 0.3
V
4.7k to 10k pull-up to Vcc,
measured at GBIC side of
connector
Table 3. Low speed signals – electronic characteristics
Min
0
Max
0.5
GBIC Input HIGH
© Finisar Corporation 01-Mar-02 Rev.F
Page 3