Regulatory information
Australia (RCM)
équivalente (p.i.r.e.) ne dépasse pas l'intensité nécessaire àl'établissement d'une communication
satisfaisante.
Firmware Version Identification number (FVIN)
XBee S2C 802.15.4 firmware versions are 2xxx or 9xxx. FVIN can be read electronically by sending the
ATVR command to the device.
Australia (RCM)
XBee S2C 802.15.4 and XBee-PRO S2C 802.15.4 modules comply with requirements to be used in end
products in Australia and New Zealand. All products with EMC and radio communications must have
registered RCM and R-NZ marks. Registration to use the compliance mark will only be accepted from
Australia or New Zealand manufacturers or importers, or their agents.
In order to have a RCM or R-NZ mark on an end product, a company must comply with a or b below.
a. Have a company presence in Australia or New Zealand.
b. Have a company/distributor/agent in Australia or New Zealand that will sponsor the importing
of the end product.
Contact Digi for questions related to locating a contact in Australia and New Zealand.
South Korea
The low-power XBee S2C TH and XBee S2C devices have received South Korean approvals. To show
conformity to the certificate, you must add a label with the South Korean product information to the
XBee S2C 802.15.4 RF Module.
For the through-hole device, you can place the label on the reverse side.
Recommended label material: Abraham Technical (700342) MFG P/N TAAE-014250.
The label size is: 15.9 mm x 15.9 mm (0.625 in x 0.625 in)
The complete label information is as follows:
XBee/XBee-PRO S2C 802.15.4 RF Module User Guide
164
ETC [ ETC ]
