ESMT
F25L32QA (2S)
Program / Erase Suspend
The Program/Erase Suspend instruction allows the system to
interrupt a Sector or Block Erase and page or Quad page
program operation and then read from, any other sector or block.
The Write Status Register instruction and Program instruction
and Sector/Block Erase instructions are not allowed during
suspend. Program/Erase Suspend is valid only during the
Program and Sector or Block Erase operation. If written during
the Chip Erase, the Program/Erase Suspend instruction is
ignored. A maximum of TSUS is required to suspend the program /
erase operation. The BUSY bit in the Software Status Register
will clear to “0” after Erase Suspend. A power-off during the
suspend period will reset the device and release the suspend
status.
CE
0
1
2
3
4
5
6
7
MODE3
TSUS
SCK MODE0
SI
75
MSB
HIGH IMPEDANCE
SO
Accept Read or Program/Erase Instruction
Figure 17: Program/Erase Suspend Instruction
Program / Erase Resume
The Program/Erase Resume instruction must be written to
resume the Page or Quad page program and Sector or Block
Erase operation after Program/Erase Suspend. After issued the
BUSY bit in the Software Status Register will be set to “1” and the
sector or block will complete the program/erase operation.
Program/Erase Resume instruction will be ignored unless an
Program/Erase Suspend operation is active.
CE
0
1
2
3
4
5
6
7
MODE3
SCK MODE0
SI
7A
MSB
Resume Sector or Block Program/Erase
Figure 18: Program/Erase Resume Instruction
Elite Semiconductor Memory Technology Inc.
Publication Date: Apr. 2013
Revision: 1.7
31/51