Ericsson Confidential
E
EXXUYNG
PRODUCT SPEC.
2 (4)
Prepared (also subject responsible if other)
No.
5/1301- BMR 658 Uen
25
Technical Specification
PKB 4000B series Intermediate Bus ConvertersDate
Approved
Checked
Rev
Reference
EN/LZT 146 384 R4A
May 2013
SEC/D (Betty Wu)
See §1
2008-11-27
B
© Ericsson AB
Input 36-75 V, Output up to 40 A / 252 W
Delivery Package Information
Hole Mount, Open Frame version
Hole Mount, Base Plate version
Soldering Information - Hole Mounting
The hole mounted product is intended for plated through hole
mounting by wave or manual soldering. The pin temperature
is specified to maximum to 270°C for maximum 10 seconds.
The products are delivered in antistatic trays.
A maximum preheat rate of 4°C/s and maximum preheat
temperature of 150°C is suggested. When soldering by hand,
care should be taken to avoid direct contact between the hot
soldering iron tip and the pins for more than a few seconds in
order to prevent overheating.
Tray Specifications
Material
PE Foam
Surface resistance
Bakability
105 < Ohm/square < 1012
The trays are not bakeable
22 mm [0.87 inch]
Tray thickness
Box capacity
A no-clean flux is recommended to avoid entrapment of
cleaning fluids in cavities inside the product or between the
product and the host board. The cleaning residues may affect
long time reliability and isolation voltage.
75 products (3 full trays/box)
Open frame version
40 g empty, 690 g full tray
Base plate version
Tray weight
40 g empty, 1165 g full tray
Delivery Package Information
Surface Mount Version
The products are delivered in antistatic injection molded trays
(Jedec design guide 4.10D standard).
Tray Specifications
Material
Antistatic PPE
Surface resistance
105 < Ohm/square < 1012
The trays can be baked at maximum
125°C for 48 hours
Bakability
Tray thickness
Box capacity
Tray weight
17.4 mm [0.685 inch]
100 products (5 full trays/box)
120 g empty, 640 g full tray
ERICSSON [ ERICSSON ]
