Page 4
Epson Research and Development
Vancouver Design Center
Building the Photon v2.0 Display Driver
The following steps build the Photon v2.0 display driver and integrate it into the QNX
operating system. These instructions assume the QNX developer environment is correctly
installed and the developer is familiar with building for the QNX operating system.
Unpack the Graphics Driver Development Kit Archive
1. Install the QNX ddk package using the Package Manager utility.
For information about the Drivers Development Kit contact QNX directly.
2. Once the ddk package is installed, copy the directory tree /usr/scr/gddk_v1.0 into the
Project directory.
3. Change directory to Project/gddk_1.0/devg.
4. Unpack the display driver files using the commands:
#gunzip S1D13506.tar.gz
#tar –xvf S1D13506.tar
This unpacks the files into the directory Project/gddk_1.0/devg/S1D13506.
Configure the Driver
The files s1d13506_16.h and s1d13506_8.h contain register values required to set the
screen resolution, color depth (bpp), display type, etc. The s1d13506.h file included with
the drivers may not contain applicable values and must be regenerated. The configuration
program 13506CFG can be used to build new s1d13506_16.h and s1d13506_8.h files.
Note
S1d13506.h should be created using the configuration utility 13506CFG. For more in-
formation on 13506CFG, see the 13506CFG Configuration Program User Manual,
document number X25B-B-001-xx available at www.erd.epson.com.
Build the Driver
The first time the driver is built, the following command ensures that all drivers and
required libraries are built. At the root of the Project source tree, type make.
Note
To build drivers for X86 NTO type ‘OSLIST=nto CPULIST=x86 make’.
Further builds do not require all libraries to be re-built. To build only the S1D13506 display
driver, change to the directory gddk_1.0/devg/S1D13506 and type make.
S1D13506
X25B-E-005-01
QNX Photon v2.0 Display Driver
Issue Date: 01/04/17
EPSON [ EPSON COMPANY ]
