Epson Research and Development
Page 5
Vancouver Design Center
Commands
The following commands are designed to be used from within the 13506PLAY program.
However, simple commands can also be executed from the command line. If a command
with multiple arguments is executed from the command line, it must be enclosed in double
quotes (e.g. 13506play “f 0 1FFFFF AB” q).
CLKI [?] iFreq
Selects a preset clock frequency (MHz) for CLKI. If the “?” option is used, the current
CLKI frequency is displayed.
Where:
?
Displays a list of available frequencies for CLKI (MHz).
Sets CLKI to a preset frequency (MHz) specified by iFreq.
iFreq
CLKI2 [?] iFreq
Selects a preset clock frequency (MHz) for CLKI2. If the “?” option is used, the current
CLKI2 frequency is displayed.
Where:
?
Displays a list of available frequencies for CLKI2 (MHz).
Sets CLKI2 to a preset frequency (MHz) specified by iFreq.
iFreq
CW word
Sends a 24-bit hexadecimal value to the programmable clock. Note that the programmable
clock documentation uses the term “word” to describe the 24-bit value. The use of “word”
does not imply a 16-bit value in this case.
F addr addr data...
Fills a specified address range with 8-bit data (bytes).
Where:
addr
data
Address range to be filled (hex).
Data to be written (hex). Data can be a list of bytes that will
be repeated for the duration of the fill. To use decimal
values, attach a “t” suffix to the value. (e.g. 100t is 100
decimal)
FD addr addr data...
Fills a specified address range with 32-bit data (dwords).
Where:
addr
data
Address range to be filled (hex).
Data to be written (hex). Data can be a list of dwords that
will be repeated for the duration of the fill. To use decimal
values, attach a “t” suffix to the value. (e.g. 100t is 100
decimal)
13506PLAY Diagnostic Utility
Issue Date: 01/02/06
S1D13506
X25B-B-003-02
EPSON [ EPSON COMPANY ]
