欢迎访问ic37.com |
会员登录 免费注册
发布采购

ACT45B-101-2P-TL003 参数 Datasheet PDF下载

ACT45B-101-2P-TL003图片预览
型号: ACT45B-101-2P-TL003
PDF下载: 下载PDF文件 查看货源
内容描述: ACT45B共模扼流圈的CAN总线系统, EIA 1812 51 ... 100 μH , 150 ... 200毫安 [ACT45B common-mode chokes for CAN bus systems, EIA 1812 51 ... 100 μH, 150 ... 200 mA]
分类和应用: 共模扼流圈PC
文件页数/大小: 7 页 / 544 K
品牌: EPCOS [ EPCOS ]
 浏览型号ACT45B-101-2P-TL003的Datasheet PDF文件第1页浏览型号ACT45B-101-2P-TL003的Datasheet PDF文件第2页浏览型号ACT45B-101-2P-TL003的Datasheet PDF文件第3页浏览型号ACT45B-101-2P-TL003的Datasheet PDF文件第4页浏览型号ACT45B-101-2P-TL003的Datasheet PDF文件第5页浏览型号ACT45B-101-2P-TL003的Datasheet PDF文件第7页  
Cautions and warnings  
Please note the recommendations in our Inductors data book (latest edition) and in the data  
sheets.  
– Particular attention should be paid to the derating curves given there.  
– The soldering conditions should also be observed. Temperatures quoted in relation to wave  
soldering refer to the pin, not the housing.  
If the components are to be washed varnished it is necessary to check whether the washing  
varnish agent that is used has a negative effect on the wire insulation, any plastics that are used,  
or on glued joints. In particular, it is possible for washing varnish agent residues to have a  
negative effect in the long-term on wire insulation.  
Washing processes may damage the product due to the possible static or cyclic mechanical  
loads (e.g. ultrasonic cleaning). They may cause cracks to develop on the product and its parts,  
which might lead to reduced reliability or lifetime.  
The following points must be observed if the components are potted in customer applications:  
– Many potting materials shrink as they harden. They therefore exert a pressure on the plastic  
housing or core. This pressure can have a deleterious effect on electrical properties, and in  
extreme cases can damage the core or plastic housing mechanically.  
– It is necessary to check whether the potting material used attacks or destroys the wire  
insulation, plastics or glue.  
– The effect of the potting material can change the high-frequency behaviour of the components.  
Ferrites are sensitive to direct impact. This can cause the core material to flake, or lead to  
breakage of the core.  
Even for customer-specific products, conclusive validation of the component in the circuit can  
only be carried out by the customer.  
Please read Cautions and warnings and  
Important notes at the end of this document.  
6
08/12