eorex
EM44AM1684LBA
Mode Register Definition
Mode Register Set
The mode register stores the data for controlling the various operating modes of DDR2 SDRAM which
contains addressing mode, burst length, /CAS latency, WR (write recovery), test mode, DLL reset and
various vendor’s specific opinions. The defaults values of the register is not defined, so the mode register
must be written after power up for proper DDR2 SDRAM operation. The mode register is written by asserting
low on /CS, /RAS, /CAS, /WE and BA0/1. The state of the address pins A0-A12 in the same cycle as /CS,
/RAS, /CAS, /WE and BA0,1 going low is written in the mode register. Two clock cycles are requested to
complete the write operation in the mode register. The mode register contents can be changed using the
same command and clock cycle requirements during operating as long as all banks are in the idle state. The
mode register is divided into various fields depending on functionality. The burst length uses A0-A2,
addressing mode uses A3, /CAS latency ( read latency from column address ) uses A4-A6. A7 is used for
test mode. A8 is used for DDR reset. A9 ~ A11 are used for write recovery time (WR) ,A7 must be set to low
for normal MRS operation. With address bit A12 two Power-Down modes can be selected, a “standard
mode” and a “low-power” Power-Down mode.
Jul. 2006
www.eorex.com
20/29