欢迎访问ic37.com |
会员登录 免费注册
发布采购

EN25S20-75WIP 参数 Datasheet PDF下载

EN25S20-75WIP图片预览
型号: EN25S20-75WIP
PDF下载: 下载PDF文件 查看货源
内容描述: 2兆位1.8V串行闪存与4K字节扇区制服 [2 Megabit 1.8V Serial Flash Memory with 4Kbyte Uniform Sector]
分类和应用: 闪存
文件页数/大小: 34 页 / 564 K
品牌: EON [ EON SILICON SOLUTION INC. ]
 浏览型号EN25S20-75WIP的Datasheet PDF文件第17页浏览型号EN25S20-75WIP的Datasheet PDF文件第18页浏览型号EN25S20-75WIP的Datasheet PDF文件第19页浏览型号EN25S20-75WIP的Datasheet PDF文件第20页浏览型号EN25S20-75WIP的Datasheet PDF文件第22页浏览型号EN25S20-75WIP的Datasheet PDF文件第23页浏览型号EN25S20-75WIP的Datasheet PDF文件第24页浏览型号EN25S20-75WIP的Datasheet PDF文件第25页  
EN25S20  
Read Manufacturer / Device ID (90h)  
The Read Manufacturer/Device ID instruction is an alternative to the Release from Power-down /  
Device ID instruction that provides both the JEDEC assigned manufacturer ID and the specific device  
ID.  
The Read Manufacturer/Device ID instruction is very similar to the Release from Power-down / Device  
ID instruction. The instruction is initiated by driving the CS# pin low and shifting the instruction code  
“90h” followed by a 24-bit address (A23-A0) of 000000h. After which, the Manufacturer ID for Eon (1Ch)  
and the Device ID are shifted out on the falling edge of CLK with most significant bit (MSB) first as  
shown in Figure 18. The Device ID values for the EN25S20 are listed in Table 5. If the 24-bit address is  
initially set to 000001h the Device ID will be read first  
Figure 18. Read Manufacturer / Device ID Diagram  
Read Identification (RDID) (9Fh)  
The Read Identification (RDID) instruction allows the 8-bit manufacturer identification to be read,  
followed by two bytes of device identification. The device identification indicates the memory type in the  
first byte , and the memory capacity of the device in the second byte .  
Any Read Identification (RDID) instruction while an Erase or Program cycle is in progress, is not  
decoded, and has no effect on the cycle that is in progress. The Read Identification (RDID) instruction  
should not be issued while the device is in Deep Power down mode.  
The device is first selected by driving Chip Select Low. Then, the 8-bit instruction code for the  
instruction is shifted in. This is followed by the 24-bit device identification, stored in the memory, being  
shifted out on Serial Data Output , each bit being shifted out during the falling edge of Serial Clock .  
The instruction sequence is shown in Figure 19. The Read Identification (RDID) instruction is  
terminated by driving Chip Select High at any time during data output.  
This Data Sheet may be revised by subsequent versions  
or modifications due to changes in technical specifications.  
©2004 Eon Silicon Solution, Inc., www.eonssi.com  
21  
Rev. H, Issue Date: 2011/11/07  
 复制成功!