EN25QH32
Figure 12.1 Fast Read Instruction Sequence under EQPI Mode
Dual Output Fast Read (3Bh)
The Dual Output Fast Read (3Bh) is similar to the standard Fast Read (0Bh) instruction except that
data is output on two pins, DQ0 and DQ1, instead of just DQ0. This allows data to be transferred from
the EN25QH32 at twice the rate of standard SPI devices. The Dual Output Fast Read instruction is
ideal for quickly downloading code from to RAM upon power-up or for applications that cache code-
segments to RAM for execution.
Similar to the Fast Read instruction, the Dual Output Fast Read instruction can operation at the highest
possible frequency of FR (see AC Electrical Characteristics). This is accomplished by adding eight
“dummy clocks after the 24-bit address as shown in Figure 13. The dummy clocks allow the device’s
internal circuits additional time for setting up the initial address. The input data during the dummy clock
is “don’t care”. However, the DI pin should be high-impedance prior to the falling edge of the first data
out clock.
This Data Sheet may be revised by subsequent versions
or modifications due to changes in technical specifications.
©2004 Eon Silicon Solution, Inc., www.eonssi.com
25
Rev. E, Issue Date: 2012/01/30
EON [ EON SILICON SOLUTION INC. ]
