CY8C24x23A Final Data Sheet
PSoC® Overview
processor. The CPU utilizes an interrupt controller with 11 vec-
tors, to simplify programming of real time embedded events.
Program execution is timed and protected using the included
Sleep and Watchdog Timers (WDT).
Memory encompasses 4 KB of Flash for program storage, 256
bytes of SRAM for data storage, and up to 2 KB of EEPROM
emulated using the Flash. Program Flash utilizes four protec-
tion levels on blocks of 64 bytes, allowing customized software
IP protection.
The PSoC device incorporates flexible internal clock genera-
tors, including a 24 MHz IMO (internal main oscillator) accurate
to 2.5% over temperature and voltage. The 24 MHz IMO can
also be doubled to 48 MHz for use by the digital system. A low
power 32 kHz ILO (internal low speed oscillator) is provided for
the Sleep timer and WDT. If crystal accuracy is desired, the
ECO (32.768 kHz external crystal oscillator) is available for use
as a Real Time Clock (RTC) and can optionally generate a crys-
tal-accurate 24 MHz system clock using a PLL. The clocks,
together with programmable clock dividers (as a System
Resource), provide the flexibility to integrate almost any timing
requirement into the PSoC device.
PSoC GPIOs provide connection to the CPU, digital and analog
resources of the device. Each pin’s drive mode may be selected
from eight options, allowing great flexibility in external interfac-
ing. Every pin also has the capability to generate a system inter-
rupt on high level, low level, and change from last read.
Digital peripheral configurations include those listed below.
■
■
■
■
■
■
■
■
■
■
PWMs (8 to 32 bit)
PWMs with Dead band (8 to 24 bit)
Counters (8 to 32 bit)
Timers (8 to 32 bit)
UART 8 bit with selectable parity
SPI master and slave
I2C slave and multi-master (1 available as a System
Resource)
Cyclical Redundancy Checker/Generator (8 to 32 bit)
IrDA
Pseudo Random Sequence Generators (8 to 32 bit)
The digital blocks can be connected to any GPIO through a
series of global buses that can route any signal to any pin. The
buses also allow for signal multiplexing and for performing logic
operations. This configurability frees your designs from the con-
straints of a fixed peripheral controller.
Digital blocks are provided in rows of four, where the number of
blocks varies by PSoC device family. This allows you the opti-
mum choice of system resources for your application. Family
resources are shown in the table titled
“PSoC Device Charac-
teristics” on page 3.
The Analog System
The Analog System is composed of 6 configurable blocks, each
comprised of an opamp circuit allowing the creation of complex
analog signal flows. Analog peripherals are very flexible and
can be customized to support specific application requirements.
Some of the more common PSoC analog functions (most avail-
able as user modules) are listed below.
■
The Digital System
The Digital System is composed of 4 digital PSoC blocks. Each
block is an 8-bit resource that can be used alone or combined
with other blocks to form 8, 16, 24, and 32-bit peripherals, which
are called user module references.
Port 1
Port 2
Port 0
Analog-to-digital converters (up to 2, with 6- to 14-bit resolu-
tion, selectable as Incremental, Delta Sigma, and SAR)
Filters (2 and 4 pole band-pass, low-pass, and notch)
Amplifiers (up to 2, with selectable gain to 48x)
Instrumentation amplifiers (1 with selectable gain to 93x)
Comparators (up to 2, with 16 selectable thresholds)
DACs (up to 2, with 6- to 9-bit resolution)
Multiplying DACs (up to 2, with 6- to 9-bit resolution)
High current output drivers (two with 30 mA drive as a PSoC
Core resource)
1.3V reference (as a System Resource)
DTMF Dialer
Modulators
Correlators
Peak Detectors
Many other topologies possible
■
■
Digital Clocks
From Core
To System Bus
To Analog
System
■
■
DIGITAL SYSTEM
Digital PSoC Block Array
Row Input
Configuration
8
8
■
■
4
8
8
Row 0
DBB00
DBB01
DCB02
■
■
■
■
Row Output
Configuration
DCB03
4
GIE[7:0]
GIO[7:0]
Global Digital
Interconnect
GOE[7:0]
GOO[7:0]
■
■
■
Digital System Block Diagram
October 17, 2006
Document No. 38-12028 Rev. *F
2
CYPRESS [ CYPRESS SEMICONDUCTOR ]
