CYW4343X
Table 38. LTE Specifications for Out-of-Band Noise Floor (Cont.)
Parameter Conditions Typical
Unit
dBm/Hz
2545–2575 MHz
XGP Band
–130
Table 39. Local Oscillator Performance
Parameter
Minimum
Typical
Maximum
Unit
LO Performance
Lock time
–
–
72
±25
–
s
Initial carrier frequency tolerance
±75
kHz
Frequency Drift
DH1 packet
DH3 packet
DH5 packet
Drift rate
–
–
–
–
±8
±8
±8
5
±25
±40
±40
20
kHz
kHz
kHz
kHz/50 µs
Frequency Deviation
00001111 sequence in payloada
140
115
–
155
140
1
175
–
kHz
kHz
MHz
10101010 sequence in payloadb
Channel spacing
–
a. This pattern represents an average deviation in payload.
b. Pattern represents the maximum deviation in payload for 99.9% of all frequency deviations.
Table 40. BLE RF Specifications
Parameter
Frequency range
Conditions
Minimum
2402
Typical
Maximum
Unit
–
–
2480
–
MHz
dBm
RX sensea
GFSK, 0.1% BER, 1 Mbps
–
–
–
–97
TX powerb
8.5
–
dBm
Mod Char: delta f1 average
–
–
225
255
–
275
–
kHz
%
Mod Char: delta f2 maxc
Mod Char: ratio
99.9
–
0.8
0.95
–
%
a. The Bluetooth tester is set so that Dirty TX is on.
b. BLE TX power can be increased to compensate for front-end losses such as BPF, diplexer, switch, etc.). The output is capped at 12 dBm. The
BLE TX power at the antenna port cannot exceed the 10 dBm specification limit.
c. At least 99.9% of all delta F2 max. frequency values recorded over 10 packets must be greater than 185 kHz.
Document No. 002-14797 Rev. *H
Page 102 of 128
CYPRESS [ CYPRESS ]
