欢迎访问ic37.com |
会员登录 免费注册
发布采购

BCM4343SKUBG 参数 Datasheet PDF下载

BCM4343SKUBG图片预览
型号: BCM4343SKUBG
PDF下载: 下载PDF文件 查看货源
内容描述: [Single-Chip IEEE 802.11 b/g/n MAC/ Baseband/Radio with Bluetooth 4.1,an FM Receiver, and Wireless Charging]
分类和应用: 无线
文件页数/大小: 127 页 / 10739 K
品牌: CYPRESS [ CYPRESS ]
 浏览型号BCM4343SKUBG的Datasheet PDF文件第97页浏览型号BCM4343SKUBG的Datasheet PDF文件第98页浏览型号BCM4343SKUBG的Datasheet PDF文件第99页浏览型号BCM4343SKUBG的Datasheet PDF文件第100页浏览型号BCM4343SKUBG的Datasheet PDF文件第102页浏览型号BCM4343SKUBG的Datasheet PDF文件第103页浏览型号BCM4343SKUBG的Datasheet PDF文件第104页浏览型号BCM4343SKUBG的Datasheet PDF文件第105页  
CYW4343X  
Table 37. Bluetooth Transmitter RF Specificationsa  
Parameter  
Conditions  
General  
Minimum Typical Maximum  
Unit  
Frequency range  
2402  
2480  
MHz  
Basic rate (GFSK) TX power at Bluetooth  
QPSK TX power at Bluetooth  
8PSK TX power at Bluetooth  
Power control step  
2
12.0  
8.0  
8.0  
4
8
dBm  
dBm  
dBm  
dB  
GFSK In-Band Spurious Emissions  
–20 dBc BW  
0.93  
1
MHz  
EDR In-Band Spurious Emissions  
1.0 MHz < |M – N| < 1.5 MHz  
1.5 MHz < |M – N| < 2.5 MHz  
M – N = the frequency range for which  
the spurious emission is measured  
relative to the transmit center frequency.  
–38  
–31  
–43  
–26.0  
–20.0  
–40.0  
dBc  
dBm  
dBm  
|M – N| 2.5 MHzb  
Out-of-Band Spurious Emissions  
–36.0 c,d  
30 MHz to 1 GHz  
dBm  
dBm  
–30.0 d,e,f  
–47.0  
1 GHz to 12.75 GHz  
1.8 GHz to 1.9 GHz  
5.15 GHz to 5.3 GHz  
dBm  
dBm  
–47.0  
GPS Band Spurious Emissions  
Spurious emissions  
–103  
dBm  
Out-of-Band Noise Floorg  
65–108 MHz  
FM RX  
–147  
–146  
–146  
–146  
–146  
–144  
–143  
–137  
dBm/Hz  
dBm/Hz  
dBm/Hz  
dBm/Hz  
dBm/Hz  
dBm/Hz  
dBm/Hz  
dBm/Hz  
776–794 MHz  
869–960 MHz  
925–960 MHz  
1570–1580 MHz  
1805–1880 MHz  
1930–1990 MHz  
2110–2170 MHz  
CDMA2000  
cdmaOne, GSM850  
E-GSM  
GPS  
GSM1800  
GSM1900, cdmaOne, WCDMA  
WCDMA  
a. Unless otherwise specified, the specifications in this table apply at the chip output port, and output power specifications are with the temperature  
correction algorithm and TSSI enabled.  
b. Typically measured at an offset of ±3 MHz.  
c. The maximum value represents the value required for Bluetooth qualification as defined in the v4.1 specification.  
d. The spurious emissions during Idle mode are the same as specified in Table 37 on page 101.  
e. Specified at the Bluetooth antenna port.  
f.  
Meets this specification using a front-end band-pass filter.  
g. Transmitted power in cellular and FM bands at the Bluetooth antenna port. See Figure 50 on page 92 for location of the port.  
Table 38. LTE Specifications for Out-of-Band Noise Floor  
Parameter  
Conditions  
Typical  
Unit  
dBm/Hz  
2500–2570 MHz  
2300–2400 MHz  
2570–2620 MHz  
Band 7  
–130  
–130  
–130  
Band 40  
Band 38  
dBm/Hz  
dBm/Hz  
Document No. 002-14797 Rev. *H  
Page 101 of 128  
 复制成功!