D A T A S H E E T
Status” for more information, and to each AC Charac-
teristics section for timing diagrams.
RESET#: Hardware Reset Pin
Note: The RESET# pin is not available on the
Am29F002NB.
Standby Mode
The RESET# pin provides a hardware method of reset-
ting the device to reading array data. When the system
When the system is not reading or writing to the device,
it can place the device in the standby mode. In this
mode, current consumption is greatly reduced, and the
outputs are placed in the high impedance state, inde-
pendent of the OE# input.
drives the RESET# pin low for at least a period of t ,
RP
the device immediately terminates any operation in
progress, tristates all data output pins, and ignores all
read/write attempts for the duration of the RESET#
pulse. The device also resets the internal state
machine to reading array data. The operation that was
interrupted should be reinitiated once the device is
ready to accept another command sequence, to
ensure data integrity.
The device enters the CMOS standby mode when CE#
and RESET# pins (CE# only on the Am29F002NB) are
both held at V
0.5 V. (Note that this is a more
CC
restricted voltage range than V .) The device enters
IH
the TTL standby mode when CE# and RESET# pins
(CE# only on the Am29F002NB) are both held at V .
IH
Current is reduced for the duration of the RESET#
The device requires standard access time (t ) for read
CE
pulse. When RESET# is held at V , the device enters
IL
access when the device is in either of these standby
modes, before it is ready to read data.
the TTL standby mode; if RESET# is held at V
SS
0.5 V, the device enters the CMOS standby mode.
The device also enters the standby mode when the
RESET# pin is driven low. Refer to the next section,
“RESET#: Hardware Reset Pin”.
The RESET# pin may be tied to the system reset cir-
cuitry. A system reset would thus also reset the Flash
memory, enabling the system to read the boot-up firm-
ware from the Flash memory.
If the device is deselected during erasure or program-
ming, the device draws active current until the
operation is completed.
Refer to the AC Characteristics tables for RESET#
parameters and timing diagram.
In the DC Characteristics tables, I
standby current specification.
represents the
CC3
Output Disable Mode
When the OE# input is at V , output from the device is
IH
disabled. The output pins are placed in the high imped-
ance state.
Table 2. Am29F002B/Am29F002NB Top Boot Block Sector Address Table
Sector Size
(Kbytes)
Address Range
Sector
SA0
SA1
SA2
SA3
SA4
SA5
SA6
A17
0
A16
0
A15
X
A14
X
A13
X
(in hexadecimal)
00000h–0FFFFh
10000h–1FFFFh
20000h–2FFFFh
30000h–37FFFh
38000h–39FFFh
3A000h–3BFFFh
3C000h–3FFFFh
64
64
64
32
8
0
1
X
X
X
1
0
X
X
X
1
1
0
X
X
1
1
1
0
0
1
1
1
0
1
8
1
1
1
1
X
16
November 17, 2009 21527D8
Am29F002B/Am29F002NB
9
CYPRESS [ CYPRESS ]
