Crane Aerospace & Electronics Power Solutions
sMsa sꢀꢁglꢂ ꢃꢁꢄ dꢅꢃl dc/dc cꢆꢁvꢂꢇꢈꢂꢇ cꢃꢉꢂꢉ
28 Voꢊt input – 5 Watt - pendinꢋ reVision F reꢊease
BOTTOM VIEW CASE C1
Projection Weld
Squared corner and dot on
top of case indicate pin one.
Seam Seal
1.075 max. (27.31)
0.932 (23.67)
1
2
3
4
5
0.025
(0.64)
dia.
0.025
(0.64)
dia.
8
7
6
0.132 (3.35)
0.000
Seal hole: 0.070 0.005 (1.78 0.13)
Case dimensions in inches (mm)
Tolerance 0.005 (0.13) for three decimal places
0.01 (0.3) for tꢀo decimal places
unless otherꢀise specified
CAUTION
Heat from refloꢀ or ꢀave soldering may damage the device.
Solder pins individually ꢀith heat application not exceeding 300°C for 10 seconds per pin
Materials
Header
Cover
Pins
Cold Rolled Steel/Nickel/Gold
Cold Rolled Steel/Nickel
Copper/Nickel/Gold compression glass seal
Case C1, Rev C, 20060116
Please refer to the numerical dimensions for accuracy. All information is believed to be accurate,
but no responsibility is assumed for errors or omissions. Interpoint reserves the right to make
changes in products or specifications ꢀithout notice.
Copyright © 1999-2006 Interpoint Corp. All rights reserved.
Figure 23: CaSe C1
www.ꢁꢆtꢀrpꢃꢁꢆt.cꢃꢉ
Pꢇꢄꢀ 11 ꢃf 14
Rꢀv F - 20090318 - Pꢀꢆꢈꢁꢆꢄ Rꢀvꢁꢂꢁꢃꢆ F Rꢀꢊꢀꢇꢂꢀ