Family Radio CTCSS 'Type 2' Encoder and Decoder
CMX808A
1.3
Signal List
Package
Signal
Description
E3
P4
Pin No. Pin No.
Name
Type
O/P
I/P
1
2
1
2
XTALN
The inverted output of the on-chip oscillator.
XTAL/CLOCK
The input to the on-chip oscillator, for external
Xtal circuit or clock.
3
4
5
3
4
5
SERIAL CLOCK
I/P
The "C-BUS" serial clock input. This clock,
produced by the µController, is used for transfer
timing of commands and data to and from the
device. See "C-BUS" Timing Diagram (Figure
4).
COMMAND DATA
REPLY DATA
I/P
The "C-BUS" serial data input from the
µController. Data is loaded into this device in
8-bit bytes, MSB (D7) first, and LSB (D0) last,
synchronised to the SERIAL CLOCK. See
"C-BUS" Timing Diagram (Figure 4).
O/P
The "C-BUS" serial data output to the
µController. The transmission of REPLY DATA
bytes is synchronised to the SERIAL CLOCK
under the control of the CSN input. This 3-state
output is held at high impedance when not
sending data to the µController. See "C-BUS"
Timing Diagram (Figure 4).
6
7
6
7
CSN
I/P
The "C-BUS" data loading control function: this
input is provided by the µController. Data
transfer sequences are initiated, completed or
aborted by the CSN signal. See "C-BUS"
Timing Diagram (Figure 4).
IRQN
O/P
This output indicates an interrupt condition to
the µController by going to a logic "0". This is a
"wire-ORable" output, enabling the connection
of up to 8 peripherals to 1 interrupt port on the
µController. This pin has a low impedance
pulldown to logic "0" when active and a high-
impedance when inactive. An external pullup
resistor is required.
An interrupt is effective if not masked out by the
IRQ MASK (bit 0 in the SUB-AUDIO CONTROL
register $80).
2003 CML Microsystems Plc
4
D/808A/6
CMLMICRO [ CML MICROCIRCUITS ]
