欢迎访问ic37.com |
会员登录 免费注册
发布采购

CMX7141L4 参数 Datasheet PDF下载

CMX7141L4图片预览
型号: CMX7141L4
PDF下载: 下载PDF文件 查看货源
内容描述: [Microprocessor, 4MHz, CMOS, PQFP48, LQFP-48]
分类和应用: 时钟外围集成电路
文件页数/大小: 74 页 / 4034 K
品牌: CMLMICRO [ CML MICROCIRCUITS ]
 浏览型号CMX7141L4的Datasheet PDF文件第31页浏览型号CMX7141L4的Datasheet PDF文件第32页浏览型号CMX7141L4的Datasheet PDF文件第33页浏览型号CMX7141L4的Datasheet PDF文件第34页浏览型号CMX7141L4的Datasheet PDF文件第36页浏览型号CMX7141L4的Datasheet PDF文件第37页浏览型号CMX7141L4的Datasheet PDF文件第38页浏览型号CMX7141L4的Datasheet PDF文件第39页  
Digital PMR Radio Processor  
CMX7131/CMX7141  
6.3.2 FI Loading from Serial Memory  
The FI must be converted into a format for the serial memory programmer (normally Intel Hex) and loaded  
into the serial memory either by the host or an external programmer. The CMX7131/CMX7141 needs to  
have the BOOTEN pins set to serial memory load, and then, on power-on, or following a C-BUS General  
Reset, the CMX7131/CMX7141 will automatically load the data from the serial memory without  
intervention from the host controller.  
BOOTEN 2 = 0  
BOOTEN 1 = 1  
Power-up or write General Reset to  
CMX7131/CMX7141  
Poll $C6 until b0 = 1 (FI loaded)  
BOOTEN1 and BOOTEN2  
may be changed from this  
Configure PRG flag interrupt if required  
point on, if required  
Read and verify checksum values in register pair:  
$A9 and $AA, $B8 and $B9  
Send Activation Code hi to $C8  
Wait for PRG flag to go high or interrupt  
Send Activation Code lo to $C8  
Jumper for  
programming  
serial memory  
(if required)  
Wait for PRG flag to go high or interrupt  
CMX7131/CMX7141 is now ready for use  
BOOTEN1  
BOOTEN2  
Figure 17 FI Loading from Serial Memory  
The CMX7131/CMX7141 has been designed to function with Atmel AT25HP512 serial EEPROM and the  
2
AT25F512 flash EEPROM devices , however other manufacturers parts may also be suitable. The time  
taken to load the FI is dependent on the Xtal frequency; with a 6.144MHz Xtal, it should load in less than 1  
second.  
NOTE:FI loading from serial memory is not supported when FI-3.1 is used in I/Q mode.  
2
Note that these two memory devices have slightly different addressing schemes. FI-3.x is compatible with both  
schemes.  
2014 CML Microsystems Plc  
Page 35  
D/7141_FI-3.x/6