CS2200-CP
8. REGISTER DESCRIPTIONS
In I²C Mode all registers are read/write unless otherwise stated. In SPI mode all registers are write only. All “Re-
served” registers must maintain their default state to ensure proper functional operation. The default state of each
bit after a power-up sequence or reset is indicated by the shaded row in the bit decode table and in the “Register
Quick Reference” on page 18.
Control port mode is entered when the device recognizes a valid chip address input on its I²C/SPI serial control pins
and the EnDevCfg1 and EnDevCfg2 bits are set to 1.
8.1
Device I.D. and Revision (Address 01h)
7
6
5
4
3
2
1
0
Device4
Device3
Device2
Device1
Device0
Revision2
Revision1
Revision0
8.1.1
8.1.2
8.2
Device Identification (Device[4:0]) - Read Only
I.D. code for the CS2200.
Device[4:0]
Device
00000
CS2200.
Device Revision (Revision[2:0]) - Read Only
CS2200 revision level.
REVID[2:0]
Revision Level
100
B2.
Device Control (Address 02h)
7
6
5
4
3
2
1
0
Unlock
Reserved
Reserved
Reserved
Reserved
Reserved
AuxOutDis
ClkOutDis
8.2.1
Unlock Indicator (Unlock) - Read Only
Indicates the lock state of the PLL.
Unlock
PLL Lock State
PLL is Locked.
PLL is Unlocked.
0
1
8.2.2
Auxiliary Output Disable (AuxOutDis)
This bit controls the output driver for the AUX_OUT pin.
AuxOutDis
Output Driver State
0
AUX_OUT output driver enabled.
AUX_OUT output driver set to high-impedance.
“Auxiliary Output” on page 14
1
Application:
DS759PP1
19
CIRRUS [ CIRRUS LOGIC ]
