BMA253
Data sheet
Page 38
device position changes in the x-y-plane while orientation changes with respect to the z-axis are
ignored. A change of the orientation of the z-axis, and hence a state change of bit (0x0C)
orient<2> is ignored (considered) when bit (0x2D) orient_ud_en is set to ‘0’ (‘1’).
BST-BMA253-DS000-01 | Revision 1.0 | August 2015
Bosch Sensortec
© Bosch Sensortec GmbH reserves all rights even in the event of industrial property rights. We reserve all rights of disposal such as copying and passing on to
third parties. BOSCH and the symbol are registered trademarks of Robert Bosch GmbH, Germany.
Note: Specifications within this document are subject to change without notice.
BOSCH [ Bosch Sensortec GmbH ]
