ARIZONA MICROTEK, INC.
AZ10LVE111E
AZ100LVE111E
ECL/PECL 1:9 Differential Clock Driver with Enable
PACKAGE AVAILABILITY
FEATURES
PACKAGE
PART NO.
MARKING NOTES
AZ10
•
•
•
•
•
•
•
•
Operating Range of 3.0V to 5.5V
Low Skew
Guaranteed Skew Spec
Differential Design
Enable
VBB Output
75kΩ Internal Input Pulldown Resistors
Direct Replacement for ON Semiconductor
MC10E111 & MC100E111
PLCC 28
LVE111E
<Date Code>
AZ100
1,2
AZ10LVE111EFN
PLCC 28
LVE111E
<Date Code>
1,2
AZ100LVE111EFN
1
2
Add R2 at end of part number for 13 inch (750 parts) Tape & Reel.
Date code format: “YY” for year followed by “WW” for week.
DESCRIPTION
The AZ10/100LVE111E is a low skew 1-to-9 differential driver, designed with clock distribution in mind. The
IN signal is fanned-out to nine identical differential outputs. An Enable input is also provided. A HIGH disables the
device by forcing all Q outputs LOW and all Q¯ outputs HIGH.
The AZ100LVE111E provides a VBB output for single-ended use or a DC bias reference for AC coupling to the
device. For single–ended input applications, the VBB reference should be connected to one side of the IN/I¯N¯
differential input pair. The input signal is then fed to the other IN/I¯N¯ input. The VBB pin should be used only as a
bias for the AZ100LVE111E as its current sink/source capability is limited. When used, the VBB pin should be
bypassed to ground via a 0.01μF capacitor.
The device is specifically designed, modeled and produced with low skew as the key goal. Optimal design and
layout serve to minimize gate-to-gate within-device skew, and empirical modeling is used to determine process
control limits that ensure consistent tpd distributions from lot-to-lot. The net result is a dependable, guaranteed low
skew device.
To ensure that the tight skew specification is met, both sides of the differential output must be terminated into
50Ω, even if only one side is used. In most applications all nine differential pairs will be used and therefore
terminated. In the case where fewer than nine pairs are used, it is necessary to terminate at least the output pairs on
the same package side (i.e. sharing the same VCCO) as the pair(s) being used on that side, in order to maintain
minimum skew. Failure to do this will result in small degradations of propagation delay (on the order of 10-20ps) of
the output(s) being used that, while not being catastrophic to most designs, will mean a loss of skew margin.
NOTE: Specifications in the ECL/PECL tables are valid when thermal equilibrium is established.
1630 S. STAPLEY DR., SUITE 127 • MESA, ARIZONA 85204 • USA • (480) 962-5881 • FAX (480) 890-2541
www.azmicrotek.com
AZM [ ARIZONA MICROTEK, INC ]
