EEPROM
AS58C1001
Austin Semiconductor, Inc.
(EXAMPLE)
Vcc
RES\
*unprogrammable
*unprogrammable
FUNCTIONAL DESCRIPTION (continued)
Write Data
Write Address
5555
(Normal Data Input)
DATA PROTECTION (continued)
2. Data protection at Vcc on/off.
AA
55
When RES\ is low, the EEPROM cannot be erased and
programmed. Therefore, data can be protected by keeping
RES\ low when Vcc is switched. RES\ should be high during
programming because it does not provide a latch function.
When Vcc is turned on or off, noise on the control pins
generated by external circuits (CPU, etc.) may turn the
EEPROM to programming mode by mistake. To prevent
this unintentional programming, the EEPROM must be kept
in an unprogrammable, standby or readout state by using a
CPU reset signal to RES\ pin.
2AAA
5555
A0
The Software data protection mode can be cancelled by
inputting the following 6 Bytes. This changes the AS58C1001
to the Non-Protection mode, for normal operation.
In addition, when RES\ is kept high at Vcc on/off timing,
the input level of control pins (CE\, OE\, WE\) must be held
as CE\=Vcc or OE\=LOW or WE\=Vcc level.
Address
5555
Data
AA
3. Software Data Protection
To protect against unintentional programming caused by
noise generated by external circuits, AS58C1001 has a
Software data protection function. To initate Software data
protection mode, 3 bytes of data must be input, followed by
a dummy write cycle of any address and any data byte. This
2AAA
5555
55
80
exact sequence switches the device into protection mode.
5555
AA
55
2AAA
5555
20
Austin Semiconductor, Inc. reserves the right to change products or specifications without notice.
AS58C1001
Rev. 5.0 7/02
5
AUSTIN [ AUSTIN SEMICONDUCTOR ]
