欢迎访问ic37.com |
会员登录 免费注册
发布采购

MEGA128CAN 参数 Datasheet PDF下载

MEGA128CAN图片预览
型号: MEGA128CAN
PDF下载: 下载PDF文件 查看货源
内容描述: 微控制器,带有ISP功能的Flash和CAN控制器128K字节 [Microcontroller WITH 128K BYTES OF ISP FLASH AND CAN CONTROLLER]
分类和应用: 微控制器
文件页数/大小: 413 页 / 5507 K
品牌: ATMEL [ ATMEL ]
 浏览型号MEGA128CAN的Datasheet PDF文件第198页浏览型号MEGA128CAN的Datasheet PDF文件第199页浏览型号MEGA128CAN的Datasheet PDF文件第200页浏览型号MEGA128CAN的Datasheet PDF文件第201页浏览型号MEGA128CAN的Datasheet PDF文件第203页浏览型号MEGA128CAN的Datasheet PDF文件第204页浏览型号MEGA128CAN的Datasheet PDF文件第205页浏览型号MEGA128CAN的Datasheet PDF文件第206页  
Figure 94. Data Packet Format  
Data MSB  
Data LSB  
ACK  
Aggregate  
SDA  
SDA from  
Transmitter  
SDA from  
Receiver  
SCL from  
Master  
1
2
7
8
9
STOP, REPEATED  
START or Next  
Data Byte  
SLA+R/W  
Data Byte  
Combining Address and Data A transmission basically consists of a START condition, a SLA+R/W, one or more data  
Packets Into a Transmission  
packets and a STOP condition. An empty message, consisting of a START followed by  
a STOP condition, is illegal. Note that the Wired-ANDing of the SCL line can be used to  
implement handshaking between the master and the slave. The slave can extend the  
SCL low period by pulling the SCL line low. This is useful if the clock speed set up by the  
master is too fast for the slave, or the slave needs extra time for processing between the  
data transmissions. The slave extending the SCL low period will not affect the SCL high  
period, which is determined by the master. As a consequence, the slave can reduce the  
TWI data transfer speed by prolonging the SCL duty cycle.  
Figure 95 shows a typical data transmission. Note that several data bytes can be trans-  
mitted between the SLA+R/W and the STOP condition, depending on the software  
protocol implemented by the application software.  
Figure 95. Typical Data Transmission  
Addr MSB  
Addr LSB R/W  
ACK  
Data MSB  
Data LSB ACK  
SDA  
SCL  
1
2
7
8
9
1
2
7
8
9
START  
SLA+R/W  
Data Byte  
STOP  
Multi-master Bus  
Systems, Arbitration and  
Synchronization  
The TWI protocol allows bus systems with several masters. Special concerns have  
been taken in order to ensure that transmissions will proceed as normal, even if two or  
more masters initiate a transmission at the same time. Two problems arise in multi-mas-  
ter systems:  
An algorithm must be implemented allowing only one of the masters to complete the  
transmission. All other masters should cease transmission when they discover that  
they have lost the selection process. This selection process is called arbitration.  
When a contending master discovers that it has lost the arbitration process, it  
should immediately switch to slave mode to check whether it is being addressed by  
the winning master. The fact that multiple masters have started transmission at the  
202  
AT90CAN128  
4250E–CAN–12/04  
 复制成功!