ATmega48PA/88PA/168PA/328P
• ADC1/PCINT9 – Port C, Bit 1
PC1 can also be used as ADC input Channel 1. Note that ADC input channel 1 uses analog
power.
PCINT9: Pin Change Interrupt source 9. The PC1 pin can serve as an external interrupt source.
• ADC0/PCINT8 – Port C, Bit 0
PC0 can also be used as ADC input Channel 0. Note that ADC input channel 0 uses analog
power.
PCINT8: Pin Change Interrupt source 8. The PC0 pin can serve as an external interrupt source.
Table 13-7 and Table 13-8 relate the alternate functions of Port C to the overriding signals
shown in Figure 13-5 on page 80.
Table 13-7. Overriding Signals for Alternate Functions in PC6..PC4(1)
Signal
Name
PUOE
PUOV
DDOE
DDOV
PVOE
PVOV
PC6/RESET/PCINT14
PC5/SCL/ADC5/PCINT13
PC4/SDA/ADC4/PCINT12
RSTDISBL
TWEN
TWEN
1
PORTC5 • PUD
TWEN
PORTC4 • PUD
TWEN
RSTDISBL
0
0
0
SCL_OUT
TWEN
SDA_OUT
TWEN
0
0
RSTDISBL + PCINT14 •
PCIE1
DIEOE
PCINT13 • PCIE1 + ADC5D
PCINT12 • PCIE1 + ADC4D
DIEOV
DI
RSTDISBL
PCINT13 • PCIE1
PCINT12 • PCIE1
PCINT14 INPUT
RESET INPUT
PCINT13 INPUT
PCINT12 INPUT
AIO
ADC5 INPUT / SCL INPUT
ADC4 INPUT / SDA INPUT
Note:
1. When enabled, the 2-wire Serial Interface enables slew-rate controls on the output pins PC4
and PC5. This is not shown in the figure. In addition, spike filters are connected between the
AIO outputs shown in the port figure and the digital logic of the TWI module.
87
8161D–AVR–10/09
ATMEL [ ATMEL ]
