TS68EN360
4. Detailed Specification
This specification describes the specific requirements for the microcontroller TS68EN360 -
25 MHz and 33 MHz in compliance with MIL-STD-883 class B or Atmel standard screening.
5. Applicable Documents
1. MIL-STD-883: test methods and procedures for electronics
2. MIL-PRF-38535: general specifications for microcircuits
3. DESC 5962-SMD-97607
The microcircuits are in accordance with the applicable document and as specified herein.
5.1
Design and Construction
5.1.1
Terminal Connections
Depending on the package, the terminal connections shall be as shown in Figure 2-1 and Figure
2-2.
5.1.2
5.1.3
Lead Material and Finish
Lead material and finish shall be as specified in MIL-STD-883 (see enclosed ”Ordering Informa-
tion” on page 79)
Package
The macrocircuits are packaged in hermetically sealed ceramic packages which are conform to
case outlines of MIL-STD-1835 or as follow:
• PGA but see ”241-pin – PGA” on page 77
• CERQUAD
The precise case outlines are described at the end of the specification (”Package Mechanical
Data” on page 77) and into MIL-STD-1835.
5.2
Absolute Maximum Ratings
Table 5-1.
Absolute Maximum Ratings
Rating
Symbol
VCC
Value
Unit
V
Supply Voltage(1)(2)
Input Voltage(1)(2)
Storage Temperature Range
-0.3 to +6.5
-0.3 to +6.5
-55 to +150
VIN
V
TSTG
°C
Notes: 1. Permanent damage can occur if maximum ratings are exceeded. Exposure to voltages or cur-
rents in excess of recommended values affects device reliability. Device modules may not
operate normally while being exposed to electrical extremes.
2. Although sections of the device contain circuitry to protect against damage from high static
voltages or electrical fields, take normal precautions to avoid exposure to voltages higher than
maximum-rated voltages.
3. The supply voltage VCC must start and restart from 0.0V; otherwise, the 360 will not come out
of reset properly.Unless otherwise stated, all voltages are referenced to the reference terminal.
11
2113B–HIREL–06/05
ATMEL [ ATMEL ]
