AX88178
USB to 10/100/1000 Gigabit Ethernet/HomePNA Controller
4.1 Detailed Description
The following sections provide detailed description for some of the field in serial EEPROM memory map, for other fields
not covered here, please refer to AX88178L application note for more details.
4.1.1 Word Count for Preload (00h)
The number of words to be preloaded by the EEPROM loader = 15h.
4.1.2 Flag (01h)
Bit 15
Bit 14
Bit 13
Reserved
Bit 5
Bit 12
Bit 11
Bit 10
Bit 9
TDPE
Bit 1
Bit 8
CEM
Bit 0
SP
Bit 7
TACE
Bit 6
RDCE
Bit 4
DCK
Bit 3
1
Bit 2
RWU
SCPR
Reserved
SP: Self-Power (for USB GetStatus)
1: Self power.
0: Bus power.
RWU: Remote Wakeup support.
1: Indicate that this device supports Remote Wakeup.
0: Not support.
DCK: Disable Chirp K.
1: Disabled.
0: Enable.
SCPR: Software Control PHY Reset.
1: The PRL and PRTE bits of Software Reset Register control the PHYRST_N output level.
0: The USB reset on USB bus and PRTE bit of Software Reset Register control the PHYRST_N output level.
RDCE: RX Drop CRC Enable.
1: CRC byte is dropped on received MAC frame forwarding to host.
0: CRC byte is not dropped.
TACE: TX Append CRC Enable.
1: CRC byte is generated and appended by the ASIC for every transmitted MAC frame.
0: CRC byte is not appended.
CEM: Capture Effective Mode.
1: Capture effective mode enable.
0: Disabled.
TDPE: Test Debug Port Enable.
1: Enable test debug port for chip debug purpose.
0: Disable test debug port and the chip operate in normal function mode
Bit 1, 10~15: Reserved.
4.1.3 Node ID (04~06h)
The Node ID 0 to 5 bytes represent the MAC address of the device, for example, if MAC address = 01-23-45-67-89-ABh,
then Node ID 0 = 01, Node ID 1 = 23, Node ID 2 = 45, Node ID 3 = 67, Node ID 4 = 89, and Node ID 5 = AB.
11
ASIX ELECTRONICS CORPORATION
ASIX [ ASIX ELECTRONICS CORPORATION ]
