Page 34 of 45
AIR BoosterPack – User’s Manual
Release Date 11/2/12
.
J4 – Radio Module Programming/Debugging Interface
0.05” pitch footprint for A2530 programming/debugging using a CC Debugger.
Table 20 – J4 A2530 Program/Debug Connector Pinout
Pin
J3-1
J3-2
J3-3
J3-4
J3-5
J3-6
J3-7
J3-8
J3-9
J3-10
Signal Name
I/O
-
O
I
Description
GND
VDD
MODULE_DC
MODULE_DD
Ground reference
Supply voltage to debugger
Radio Module Debug Clock
I/O Radio Module Debug Data
-
-
I
-
-
-
-
-
MRST
Radio Module Hardware Reset – active low
-
-
-
.
J5 – Radio Module GPIO Interface
0.1” pitch thru-hole footprint which provides access to the Radio Module’s four GPIO
signals. For applications requiring use of these pins, the LEDs and 2KΩ pull-down
resistors sharing the GPIO signals may be electrically isolated by turning off the S4 DIP
switches (see Table 5 for more info regarding the DIP switches).
Table 21 – J5 A2530 GPIO Connector Pinout
Pin
J3-1
J3-2
J3-3
J3-4
J3-5
J3-6
Signal Name
GND
I/O
-
O
Description
Ground reference
Supply voltage
VDD
GPIO1
GPIO0
GPIO3
GPIO2
I/O Radio Module P0.1
I/O Radio Module P0.0
I/O Radio Module P1.0
I/O Radio Module P0.6
.
J101 – External Power Interface
2mm pitch shrouded header for connecting external power (e.g. from a battery) to the
BoosterPack. The positive terminal has a series Schottky diode to prevent accidental
battery charging in the event the BoosterPack is installed on a powered LaunchPad.
Table 22 – J101 External Power (Battery) Connector Pinout
Pin
J101-1
J101-2
Signal Name
GND
I/O
-
I
Description
Ground reference
Supply voltage
VDD
ANAREN [ ANAREN MICROWAVE ]
