PRODUCT DATASHEET
AAT2146
TM
SwitchReg
Low Noise, FastTransient 600mA Step-Down Converter
A high density, small footprint layout can be achieved
using an inexpensive, miniature, non-shielded, high DCR
inductor. An evaluation board is available with this induc-
tor and is shown in Figure 6. The total solution footprint
area is 40mm2.
Layout
The suggested PCB layout for the AAT2146 is shown in
Figures 2, 3, and 4. The following guidelines should be
used to help ensure a proper layout.
1. The input capacitor (C2) should connect as closely as
possible to VIN (Pin 3) and PGND (Pins 6-8).
2. C1 and L1 should be connected as closely as possi-
ble. The connection of L1 to the LX pin should be as
short as possible.
3. The feedback trace or OUT pin (Pin 2) should be
separate from any power trace and connect as close-
ly as possible to the load point. Sensing along a
high-current load trace will degrade DC load regula-
tion. If external feedback resistors are used, they
should be placed as closely as possible to the OUT
pin (Pin 2) to minimize the length of the high imped-
ance feedback trace.
4. The resistance of the trace from the load return to
the PGND (Pins 6-8) should be kept to a minimum.
This will help to minimize any error in DC regulation
due to differences in the potential of the internal
signal ground and the power ground.
Figure 6: Minimum Footprint Evaluation Board
Using 2.0mm x 1.6mm x 0.95mm Inductor.
w w w . a n a l o g i c t e c h . c o m
2146.2008.10.1.2
15
ANALOGICTECH [ ADVANCED ANALOGIC TECHNOLOGIES ]
