欢迎访问ic37.com |
会员登录 免费注册
发布采购

PPC440GX-3CF533C 参数 Datasheet PDF下载

PPC440GX-3CF533C图片预览
型号: PPC440GX-3CF533C
PDF下载: 下载PDF文件 查看货源
内容描述: 的Power PC 440GX嵌入式处理器 [Power PC 440GX Embedded Processor]
分类和应用: PC
文件页数/大小: 93 页 / 1501 K
品牌: AMCC [ APPLIED MICRO CIRCUITS CORPORATION ]
 浏览型号PPC440GX-3CF533C的Datasheet PDF文件第8页浏览型号PPC440GX-3CF533C的Datasheet PDF文件第9页浏览型号PPC440GX-3CF533C的Datasheet PDF文件第10页浏览型号PPC440GX-3CF533C的Datasheet PDF文件第11页浏览型号PPC440GX-3CF533C的Datasheet PDF文件第13页浏览型号PPC440GX-3CF533C的Datasheet PDF文件第14页浏览型号PPC440GX-3CF533C的Datasheet PDF文件第15页浏览型号PPC440GX-3CF533C的Datasheet PDF文件第16页  
Revision 1.15 – August 30, 2007  
440GX – Power PC 440GX Embedded Processor  
Data Sheet  
• Simple message passing capability  
• Asynchronous to the PLB  
• PCI Power Management 1.1  
• PCI register set addressable both from on-chip processor and PCI device sides  
• Ability to boot from PCI-X bus memory  
• Error tracking/status  
• Supports initiation of transfer to the following address spaces:  
- Single beat I/O reads and writes  
- Single beat and burst memory reads and writes  
- Single beat configuration reads and writes (type 0 and type 1)  
- Single beat special cycles  
DDR SDRAM Memory Controller  
The Double Data Rate (DDR) SDRAM memory controller supports industry standard 184-pin DIMMs, SO-DIMMs,  
and other discrete devices. Up to four 512MB logical banks are supported in limited configurations. Global memory  
timings, address and bank sizes, and memory addressing modes are programmable.  
Features include:  
• Registered and non-registered industry standard DIMMs  
• 64-bit memory interface with optional 8-bit ECC (SEC/DED)  
• Sustainable 2.6GB/s peak bandwidth at 166MHz (200MHz for 800MHz Rev F parts)  
• SSTL_2 logic  
• 1 to 4 chip selects  
• CAS latencies of 2, 2.5 and 3 supported  
• DDR200/266/333 support  
• Page mode accesses (up to eight open pages) with configurable paging policy  
• Programmable address mapping and timing  
• Hardware and software initiated self-refresh  
• Power management (self-refresh, suspend, sleep)  
External Peripheral Bus Controller (EBC)  
Features include:  
• Up to eight ROM, EPROM, SRAM, Flash memory, and slave peripheral I/O banks supported  
• Up to 83.33MHz operation (333MB/s)  
• Burst and non-burst devices  
• 8-, 16-, 32-bit byte-addressable data bus  
• 32-bit address, 4GB address space  
• Peripheral Device pacing with external “Ready”  
• Latch data on Ready, synchronous or asynchronous  
• Programmable access timing per device  
- 256 Wait States for non-burst  
- 32 Burst Wait States for first access and up to 8 Wait States for subsequent accesses  
- Programmable CSon, CSoff relative to address  
- Programmable OEon, WEon, WEoff (1 to 4 clock cycles) relative to CS  
• Programmable address mapping  
• External DMA Slave Support  
12  
AMCC