Revision 1.23 - January 28, 2009
PPC405EX – PowerPC 405EX Embedded Processor
Data Sheet
Ratings and Specifications
Table 7. Absolute Maximum Ratings
The absolute maximum ratings below are stress ratings only. Operation at or beyond these maximum ratings can cause
permanent damage to the device. None of the performance specification contained in this document are guaranteed when
operating at these maximum ratings.
Characteristic
Logic Supply Voltage (internal logic)
PCI-Express SerDes Analog Supply Voltage
PCI-Express SerDes PLL Analog Supply Voltage
I/O Supply Voltage
Symbol
Value
0 to +1.6
Unit
V
Notes
VDD
AVDD
AHVDD
OVDD
SVDD
EOVDD
SAVDD
EAVDD
VIN
0 to +1.6
V
1
1
0 to +2.6
V
0 to +3.6
V
SDRAM DDR1[2] Supply Voltage
Ethernet I/O Supply Voltage
0 to +2.6 [+1.9]
0 to +2.6
V
V
System PLL Analog Supply Voltage
Ethernet PLL Analog Supply Voltage
Input voltage (3.3V LVTTL receivers)
Storage Temperature Range
0 to +2.6
V
1
1
0 to +2.6
V
0 to +3.6
V
TSTG
−55 to +150
−40 to +120
−40 to +125
°C
°C
°C
TC
Case Temperature Range under bias
Junction Temperature Range
TJMax
2
Notes:
1. The analog voltages can be derived from the +1.2V and +2.5V supplies, but must be filtered as shown below before entering the
PPC405EX. Use a separate filter for each voltage. This circuit can be used for AVDD, AHVDD , SAVDD, and EAVDD. Use AGND
with AVDD and AHVDD. Use SAGND with SAVDD. Use EAGND with EAVDD. These analog grounds must be brought out and
connected to the digital ground plane at the filter capacitor. Keep all wire lengths as short as possible.
V
AV
DD
DD
L1 – Murata BLM18AG121SN1D
L1
C1
C1 – 0.1 μF ceramic
AGND
GND
2. The device meets all electrical specifications at a junction temperature, under bias, of 125ºC, but part lifetime and reliability is
reduced. It is recommended that prudent thermal management techniques be used to maximize device lifetime.
46
AMCC Proprietary