External Memory Interfaces
Table 9–1 shows the external memory interfaces supported in Cyclone II
devices.
Cyclone II DDR
Memory Support
Overview
Table 9–1. External Memory Support in Cyclone II Devices
Note (1)
Maximum Clock
Maximum Data
Rate Supported
(Mbps)
Maximum Bus
Width
Memory Standard
I/O Standard
Rate Supported
(MHz)
DDR SDRAM
SSTL-2 class I (2)
72
72
72
72
36
36
167
133
167
125
167
100
333 (1)
267 (1)
333 (1)
250 (1)
667 (1)
400 (1)
SSTL-2 class II (2)
SSTL-18 class I (2)
SSTL-18 class II (3)
1.8-V HSTL class I (2)
1.8-V HSTL class II (3)
DDR2 SDRAM
QDRII SRAM (4)
Notes to Table 9–1:
(1) The data rate is for designs using the clock delay control circuitry.
(2) These I/O standards are supported on all the I/O banks of the Cyclone II device.
(3) These I/O standards are supported only on the I/O banks on the top and bottom of the Cyclone II device.
(4) For maximum performance, Altera recommends using the 1.8-V HSTL I/O standard because of higher I/O drive
strength. QDRII SRAM devices also support the 1.5-V HSTL I/O standard.
Cyclone II devices support the data strobe or read clock signal (DQS)
used in DDR SDRAM with the clock delay control circuitry that can shift
the incoming DQS signals to center them within the data window. To
achieve DDR operation, the DDR input and output registers are
implemented using the internal logic element (LE) registers. You should
use the altdqsand altdqmegafunctions in the Quartus II software to
implement the DDR registers used for DQS and DQ signals, respectively.
Altera Corporation
February 2007
9–9
Cyclone II Device Handbook, Volume 1