Selectable I/O Standards in Cyclone II Devices
software makes it easy to use these I/O standards in Cyclone II device
designs. After design compilation, the software also provides clear, visual
representations of pads and pins and the selected I/O standards. Taking
advantage of the support of these I/O standards in Cyclone II devices
allows you to lower your design costs without compromising design
flexibility or complexity.
For more information on the I/O standards referred to in this document,
refer to the following sources:
References
■
■
Stub Series Terminated Logic for 2.5-V (SSTL-2), JESD8-9A,
Electronic Industries Association, December 2000.
1.5-V +/- 0.1-V (Normal Range) and 0.9-V - 1.6-V (Wide Range)
Power Supply Voltage and Interface Standard for Non-terminated
Digital Integrated Circuits, JESD8-11, Electronic Industries
Association, October 2000.
■
■
1.8-V +/- 0.15-V (Normal Range) and 1.2-V - 1.95-V (Wide Range)
Power Supply Voltage and Interface Standard for Non-terminated
Digital Integrated Circuits, JESD8-7, Electronic Industries
Association, February 1997.
2.5-V +/- 0.2-V (Normal Range) and 1.8-V to 2.7-V (Wide Range)
Power Supply Voltage and Interface Standard for Non-terminated
Digital Integrated Circuits, JESD8-5, Electronic Industries
Association, October 1995.
■
■
■
Interface Standard for Nominal 3-V/ 3.3-V Supply Digital Integrated
Circuits, JESD8-B, Electronic Industries Association, September 1999.
PCI Local Bus Specification, Revision 2.2, PCI Special Interest Group,
December 1998.
Electrical Characteristics of Low Voltage Differential Signaling
(LVDS) Interface Circuits, ANSI/TIA/EIA-644, American National
Standards Institute/Telecommunications Industry/Electronic
Industries Association, October 1995.
Altera Corporation
February 2008
10–37
Cyclone II Device Handbook, Volume 1
ALTERA [ ALTERA CORPORATION ]
