欢迎访问ic37.com |
会员登录 免费注册
发布采购

EP1C6F256I8 参数 Datasheet PDF下载

EP1C6F256I8图片预览
型号: EP1C6F256I8
PDF下载: 下载PDF文件 查看货源
内容描述: 气旋FPGA系列 [Cyclone FPGA Family]
分类和应用: 可编程逻辑时钟
文件页数/大小: 94 页 / 1066 K
品牌: ALTERA [ ALTERA CORPORATION ]
 浏览型号EP1C6F256I8的Datasheet PDF文件第52页浏览型号EP1C6F256I8的Datasheet PDF文件第53页浏览型号EP1C6F256I8的Datasheet PDF文件第54页浏览型号EP1C6F256I8的Datasheet PDF文件第55页浏览型号EP1C6F256I8的Datasheet PDF文件第57页浏览型号EP1C6F256I8的Datasheet PDF文件第58页浏览型号EP1C6F256I8的Datasheet PDF文件第59页浏览型号EP1C6F256I8的Datasheet PDF文件第60页  
Cyclone FPGA Family Data Sheet  
Preliminary Information  
Slew-Rate Control  
The output buffer for each Cyclone device I/O pin has a programmable  
output slew-rate control that can be configured for low noise or high-  
speed performance. A faster slew rate provides high-speed transitions for  
high-performance systems. However, these fast transitions may introduce  
noise transients into the system. A slow slew rate reduces system noise,  
but adds a nominal delay to rising and falling edges. Each I/O pin has an  
individual slew-rate control, allowing the designer to specify the slew rate  
on a pin-by-pin basis. The slew-rate control affects both the rising and  
falling edges.  
Bus Hold  
Each Cyclone device I/O pin provides an optional bus-hold feature. The  
bus-hold circuitry can hold the signal on an I/O pin at its last-driven state.  
Since the bus-hold feature holds the last-driven state of the pin until the  
next input signal is present, an external pull-up or pull-down resistor is  
not necessary to hold a signal level when the bus is tri-stated.  
The bus-hold circuitry also pulls undriven pins away from the input  
threshold voltage where noise can cause unintended high-frequency  
switching. The designer can select this feature individually for each I/O  
pin. The bus-hold output will drive no higher than VCCIO to prevent  
overdriving signals. If the bus-hold feature is enabled, the device cannot  
use the programmable pull-up option. Disable the bus-hold feature when  
the I/O pin is configured for differential signals.  
The bus-hold circuitry uses a resistor with a nominal resistance (RBH) of  
approximately 7 kto pull the signal level to the last-driven state.  
Table 37 on page 72 gives the specific sustaining current for each VCCIO  
voltage level driven through this resistor and overdrive current used to  
identify the next-driven input level.  
The bus-hold circuitry is only active after configuration. When going into  
user mode, the bus-hold circuit captures the value on the pin present at  
the end of configuration.  
Programmable Pull-Up Resistor  
Each Cyclone device I/O pin provides an optional programmable pull-up  
resistor during user mode. If the designer enables this feature for an I/O  
pin, the pull-up resistor (typically 25 k) holds the output to the VCCIO  
level of the output pin’s bank.  
56  
Altera Corporation  
 复制成功!