Stratix II EP2S60 DSP Development Board Data Sheet
3. Insert a thin, flat tool (small flat-head screwdriver, tweezers, or any
clip tool) into the clip’s pry hole, and use it to gently push the clip on
the edge of the FPGA. Snap the clip down to secure the heat sink.
See Figure 15.
Figure 15. Attach the Clip
4. Attach the heat sink fan power connector to the J36 connector, for
5 V DC power.
Remove the Active Heat Sink
To remove the heat sink and fan from the board, perform the following
steps:
1. Disconnect the heat sink fan power connector from the J36
connector.
2. Insert the thin, flat tool into one of the clip’s pry holes. Using the
tool, slightly push away and lift the plastic clip from the FPGA to
detach one side of the heat sink.
3. Repeat step 2 on the other side of the plastic clip to remove the heat
sink completely.
50
Altera Corporation
Preliminary
ALTERA [ ALTERA CORPORATION ]
