Operating Conditions
Table 5–4. Stratix II Device DC Operating Conditions (Part 2 of 2)
Note (1)
Symbol
Parameter
Conditions
Minimum Typical Maximum Unit
ICCI00
VCCIO supply current
(standby)
VI = ground, no
load, no toggling
inputs
EP2S15
EP2S30
EP2S60
EP2S90
EP2S130
EP2S180
4.0
4.0
4.0
4.0
4.0
4.0
25
35
50
75
90
1
(3)
(3)
(3)
(3)
(3)
(3)
50
mA
mA
mA
mA
mA
mA
kΩ
kΩ
kΩ
kΩ
kΩ
kΩ
TJ = 25° C
RCONF (4) Value of I/O pin pull-up
resistor before and
Vi = 0; VCCIO = 3.3 V
Vi = 0; VCCIO = 2.5 V
Vi = 0; VCCIO = 1.8 V
Vi = 0; VCCIO = 1.5 V
Vi = 0; VCCIO = 1.2 V
10
15
30
40
50
70
during configuration
100
150
170
2
Recommended value of
I/O pin external
pull-downresistorbefore
and during configuration
Notes to Table 5–4:
(1) Typical values are for TA = 25°C, VCCINT = 1.2 V, and VCCIO = 1.5 V, 1.8 V, 2.5 V, and 3.3 V.
(2) This value is specified for normal device operation. The value may vary during power-up. This applies for all
VCCIO settings (3.3, 2.5, 1.8, and 1.5 V).
(3) Maximum values depend on the actual TJ and design utilization. See the Excel-based PowerPlay Early Power
Estimator (available at www.altera.com) or the Quartus II PowerPlay Power Analyzer feature for maximum
values. See the section “Power Consumption” on page 5–20 for more information.
(4) Pin pull-up resistance values are lower if an external source drives the pin higher than VCCIO
.
I/O Standard Specifications
Tables 5–5 through 5–32 show the Stratix II device family I/O standard
specifications.
Table 5–5. LVTTL Specifications (Part 1 of 2)
Symbol
VCCIO (1)
VIH
Parameter
Output supply voltage
High-level input voltage
Low-level input voltage
High-level output voltage
Conditions
Minimum
3.135
1.7
Maximum
3.465
4.0
Unit
V
V
VIL
–0.3
0.8
V
VOH
IOH = –4 mA (2)
2.4
V
5–4
Altera Corporation
April 2011
Stratix II Device Handbook, Volume 1
ALTERA [ ALTERA CORPORATION ]
