ASAHI KASEI
[AK8817/18]
(5) Current consumption
(5-1) AK8817VG / AK8818VG
< Operating voltage : DVDD = AVDD = PVDD = 3.0 V, Ta = +25 °C >
Parameter
Symbol
Min
Typ
Max
mA
uA
Units
Total power consumption
27
35
Note1)
Note2)
Note3)
Note4)
Note5)
Note6)
Power-down current 1
10
30
Digital part operating current 1
Analog part operating current 1
Analog part operating current 2
Analog part operating current 3
13
mA
mA
mA
mA
14
5.5
0.8
(5-1) AK8817VQ / AK8818VQ
< Operating voltage : DVDD = AVDD = PVDD = 3.3 V, Ta = +25 °C >
Parameter
Symbol
Min
Typ
Max
mA
uA
Units
Total power consumption
29
38
Note1)
Note2)
Note3)
Note4)
Note5)
Note6)
Power-down current 1
10
30
Digital part operating current 1
Analog part operating current 1
Analog part operating current 2
Analog part operating current 3
13
mA
mA
mA
mA
14
5.5
0.8
Note1) operation at 27 MHz, NTSC mode on-chip 75% color bar output is enabled and Video Amp output is “ on “ ( no
external output loads are connected except for recommended components. ). 15pF capacitors in following figure represent
PCB layout-capacitor.
AK8817
SAG
VOUT
15pF
AK8817
SAG
VOUT
15pF
100uF
1uF
75ohm
75ohm
47uF
75ohm
75ohm
15pF
15pF
SAG Compensation OFF
SAG Compensation ON
Note2) measuring conditions :
input / output settings after power-down sequence are, PDN pin is at GND level, CLKOUT and SDO output are at high
level ( power supply voltage ) with no external connection, input voltage on those input pins is 1/2 level of power supply
which are set to accept Hi-Z input at power-down, and TEST = ATPG = GND ( or left open ).
Power supplies are AVDD = DVSS = PVDD.
Each ground pin ( DVSS, AVSS, PVSS ) is always 0 V ( voltage reference ).
Note3) Operation at 27 MHz, NTSC mode on-chip 75% color bar output is enabled.
Note4) DAC ON, Video Amp On SAG Compensation On
Note5) DAC ON, Video Amp Off (SAG Compensation Off)
Note6) DAC Off, Video Amp Off (SAG Compensation Off)
Rev.001E
12
2009 / 12
AKM [ ASAHI KASEI MICROSYSTEMS ]
