[AK09916]
9.4. Description of Each Operation Mode
9.4.1. Power-down Mode
Power to almost all internal circuits is turned off. All registers are accessible in Power-down mode. Data
stored in read/write registers are remained. They can be reset by soft reset.
9.4.2. Single Measurement Mode
When Single measurement mode (MODE[4:0] bits = “00001”) is set, magnetic sensor measurement is
started. After magnetic sensor measurement and signal processing is finished, measurement magnetic data is
stored to measurement data registers (HXL to HZH), then AK09916 transits to Power-down mode
automatically. On transition to Power-down mode, MODE[4:0] bits turns to “00000”. At the same time,
DRDY bit in ST1 register turns to “1”. This is called “Data Ready”. When any of measurement data register
(HXL to TMPS) or ST2 register is read, DRDY bit turns to “0”. It remains “1” on transition from
Power-down mode to another mode. (Figure 9.2. )
When sensor is measuring (Measurement period), measurement data registers (HXL to TMPS) keep the
previous data. Therefore, it is possible to read out data even in measurement period. Data read out in
measurement period are previous data.(Figure 9.3. )
Operation Mode:
Power-down
Single measuremnet
(1)
(2)
(3)
Measurement period
Measurement Data Register
Last Data
Measurement Data (1)
Data(2)
Data(3)
DRDY
Data read
Data(1)
Data(3)
Register Write
MODE[4:0]="00001"
MODE[4:0]="00001" MODE[4:0]="00001"
Figure 9.2. Single measurement mode when data is read out of measurement period
Operation Mode:
Power-down
Single measuremnet
(1)
(2)
(3)
Measurement period
Measurement Data Register
Last Data
Measurement Data (1)
Data(3)
DRDY
Data read
Data(1)
Register Write
MODE[4:0]="00001"
MODE[4:0]="00001" MODE[4:0]="00001"
Figure 9.3. Single measurement mode when data read started during measurement period
015007392-E-02
2015/12
- 10 -
AKM [ ASAHI KASEI MICROSYSTEMS ]
