欢迎访问ic37.com |
会员登录 免费注册
发布采购

ACT4468DI 参数 Datasheet PDF下载

ACT4468DI图片预览
型号: ACT4468DI
PDF下载: 下载PDF文件 查看货源
内容描述: ACT4468D双收发器为MIL -STD-1553 [ACT4468D Dual Transceivers for MIL-STD-1553]
分类和应用: 驱动器
文件页数/大小: 6 页 / 84 K
品牌: AEROFLEX [ AEROFLEX CIRCUIT TECHNOLOGY ]
 浏览型号ACT4468DI的Datasheet PDF文件第2页浏览型号ACT4468DI的Datasheet PDF文件第3页浏览型号ACT4468DI的Datasheet PDF文件第4页浏览型号ACT4468DI的Datasheet PDF文件第5页浏览型号ACT4468DI的Datasheet PDF文件第6页  
ACT4468D  
Dual Transceivers for MIL-STD-1553  
Features  
CIRCUIT TECHNOLOGY  
• World’s smallest and lowest standby power dual  
transceiver 0.3" x 1" packages  
www.aeroflex.com  
General Description  
• Dual transceiver meets military data bus  
The Aeroflex Circuit Technology  
requirements, MIL-STD-1553 and MIL-STD-1760  
• Low power dissipation at full output power  
• Single +5V power supply  
Model ACT4468D is  
a
next  
generation D.I. monolithic transceiver  
which provide full compliance with  
MIL-STD-1553/1760 and data bus  
requirements  
in  
the  
smallest  
• Current source output  
• Monolithic construction using dielectrically  
isolated(D.I.)  
packages with the lowest standby  
power consumption and one power  
supply operation.  
The dual channel Model ACT4468D  
perform the front-end analog function  
of inputting and outputting data  
• Processed and screened to MIL-STD-883 specs  
• DESC SMD# 5962–92061 Pending  
through  
a
transformer  
to  
a
MIL-STD-1553/1760 data bus.  
Design of these transceivers reflects  
particular attention to active filter  
performance. This results in low bit  
and word error rate with superior  
waveform purity and minimal zero  
crossover  
distortion.  
Efficient  
transmitter electrical and thermal  
design provides low internal power  
dissipation and heat rise at high as  
well as low duty cycles.  
Each channel of the dual transceiver  
is completely separate from the other  
and fully independent. This includes  
power leads as well as signal lines.  
Hence, each channel may be  
connected to a different data bus with  
no interaction.  
ACT4468D Dual Transceiver  
TX/RX  
TX DATA IN  
Transmitter:  
OUTPUT  
STAGE  
DRIVER  
SHAPING  
TX/RX  
TX DATA IN  
The Transmitter section accepts  
bi-phase TTL data at the input and  
when coupled to the data bus with a  
1:2.5 transformer, isolated on the  
data bus side with two 52.5 Ohm fault  
isolation resistors, and loaded by two  
70 Ohm terminations plus additional  
receivers, the data bus signal  
produced is 7.5Volts nominal P-P at  
A-A’. (See Figure 5.) When both  
DATA and DATA inputs are held low or  
high, the transmitter output becomes  
TX INHIBIT  
RX DATA OUT  
COMP.  
COMP.  
+5 V  
REFERENCE  
GROUND  
RX DATA OUT  
ACTIVE  
FILTER  
INPUT  
AMP  
STROBE  
Block Diagram (without Transformer), 1/2 of unit shown  
eroflex Circuit Technology – Data Bus Modules For The Future © SCD4468D REV B 5/25/00  
 复制成功!