1.3 Absolute maximum ratings. 1/
Supply voltage range (±VS).....................................................±22 V
Input voltage range (VIN) .........................................................±20 V 2/
Differential input voltage range................................................±40 V
Power dissipation (PD).............................................................670 mW
Output short circuit duration....................................................Unlimited 3/
Junction temperature (TJ) .......................................................175°C 4/
Storage temperature range.....................................................-65°C to +150°C
Lead temperature (soldering, 60 seconds).............................300°C
Thermal resistance, junction-to-case (qJC)..............................See MIL-STD-1835
Thermal resistance, junction-to-ambient (qJA):
Case G.................................................................................150°C/W
Case P .................................................................................120°C/W
1.4 Recommended operating conditions.
Supply voltage range (±VS).....................................................±5 V dc to 20 V dc
Ambient temperature range (TA).............................................-55°C to +125°C
1.5 Radiation features.
Total dose................................................................................£ 100 Krads
2. APPLICABLE DOCUMENTS
2.1 Government specification, standards, and handbooks. The following specification, standards, and handbooks form a part of
this drawing to the extent specified herein. Unless otherwise specified, the issues of these documents are those listed in the issue
of the Department of Defense Index of Specifications and Standards (DoDISS) and supplement thereto, cited in the solicitation.
SPECIFICATION
DEPARTMENT OF DEFENSE
MIL-PRF-38535 - Integrated Circuits, Manufacturing, General Specification for.
STANDARDS
DEPARTMENT OF DEFENSE
MIL-STD-883
MIL-STD-973
-
-
Test Method Standard Microcircuits.
Configuration Management.
MIL-STD-1835 - Interface Standard For Microcircuit Case Outlines.
1/ Stresses above the absolute maximum rating may cause permanent damage to the device. Extended operation at the
maximum levels may degrade performance and affect reliability.
2/ The absolute maximum negative input voltage is equal to the negative power supply voltage.
3/ Short circuit may be to ground or either supply. Rating applies to +125°C case temperature or +75°C ambient temperature.
4/ For short term test (in the specific burn-in and life test configuration when required and up to 168°C hours maximum),
TJ = 275°C.
SIZE
STANDARD
MICROCIRCUIT DRAWING
5962-98636
A
DEFENSE SUPPLY CENTER COLUMBUS
COLUMBUS, OHIO 43216-5000
REVISION LEVEL
SHEET
A
3
DSCC FORM 2234
APR 97
ADI [ ADI ]
