1.4 Recommended operating conditions.
Power supply
Operating voltage range:
Positive supply (VLOG).................................................................................................... +4.5 V dc to +5.5 V dc
Positive supply (VCC) ..................................................................................................... +11.4 V dc to +16.5 V dc
Negative supply (VEE).................................................................................................... -11.4 V dc to -16.5 V dc
Ambient operating temperature range................................................................................. -55°C to +125°C
1.5 Radiation features.
Maximum total dose available (dose rate = 50 – 300 rad(Si)/s) .......................................... ≤100 Krads (Si)
2. APPLICABLE DOCUMENTS
2.1 Government specification, standards, and handbooks. The following specification, standards, and handbooks form a part of
this drawing to the extent specified herein. Unless otherwise specified, the issues of these documents are those listed in the issue
of the Department of Defense Index of Specifications and Standards (DoDISS) and supplement thereto, cited in the solicitation.
SPECIFICATION
DEPARTMENT OF DEFENSE
MIL-PRF-38535 - Integrated Circuits, Manufacturing, General Specification for.
STANDARDS
DEPARTMENT OF DEFENSE
MIL-STD-883
-
Test Method Standard Microcircuits.
MIL-STD-1835 - Interface Standard Electronic Component Case Outlines.
HANDBOOKS
DEPARTMENT OF DEFENSE
MIL-HDBK-103 - List of Standard Microcircuit Drawings.
MIL-HDBK-780 - Standard Microcircuit Drawings.
(Unless otherwise indicated, copies of the specification, standards, and handbooks are available from the Standardization
Document Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094.)
2.2 Order of precedence. In the event of a conflict between the text of this drawing and the references cited herein, the text of
this drawing takes precedence. Nothing in this document, however, supersedes applicable laws and regulations unless a specific
exemption has been obtained.
3. REQUIREMENTS
3.1 Item requirements. The individual item requirements for device classes Q and V shall be in accordance with
MIL-PRF-38535 and as specified herein or as modified in the device manufacturer's Quality Management (QM) plan. The
modification in the QM plan shall not affect the form, fit, or function as described herein. The individual item requirements for device
class M shall be in accordance with MIL-PRF-38535, appendix A for non-JAN class level B devices and as specified herein.
SIZE
STANDARD
MICROCIRCUIT DRAWING
5962-85127
A
DEFENSE SUPPLY CENTER COLUMBUS
COLUMBUS, OHIO 43216-5000
REVISION LEVEL
H
SHEET
4
DSCC FORM 2234
APR 97
ADI [ ADI ]
