1.3 Absolute maximum ratings. 1/
Supply voltage (V )...................................................................................... 22 V
S
Internal power dissipation ........................................................................... 500 mW
Input voltage ................................................................................................ 22 V 2/
Output short-circuit duration ........................................................................ Indefinite
Differential input voltage .............................................................................. 0.7 V 3/
Differential input current .............................................................................. 25 mA 3/
Storage temperature range ......................................................................... -65C to +150C
Operating temperature range ...................................................................... -55C to +125C
Lead temperature (soldering, 60 seconds) .................................................. +300C
Junction temperature range (T ) .................................................................. -65C to +150C
J
Thermal resistance, junction-to-case (JC) .................................................. See MIL-STD-1835
Thermal resistance, junction-to-ambient (JA):
Cases G and H ......................................................................................... 150C/W
Case P ..................................................................................................... 119C/W
Case 2 ...................................................................................................... 110C/W
1.4 Recommended operating conditions.
Supply voltage (V ) ..................................................................................... 4.5 V to 18 V
S
Source resistor (R ) .................................................................................... 50
S
Ambient operating temperature range (T ) ................................................. -55C to +125C
A
1.5 Radiation features:
Device type 02:
Maximum total dose available (dose rate = 50 – 300 rads(Si)/s) ................. 100 krads (Si) 4/
Device type 03:
Maximum total dose available (dose rate 10 m rads(Si)/s) ....................... 50 krads (Si) 5/
_____
1/ Stresses above the absolute maximum rating may cause permanent damage to the device. Extended operation at the
maximum levels may degrade performance and affect reliability.
2/ For supply voltages less than 22 V, the absolute maximum input voltage is equal to the supply voltages.
3/ The device inputs are protected by back-to-back diodes. Current limiting resistors are not used in order to achieve low
noise. If differential input voltage exceeds 0.7 V, the input current should be limited to 25 mA.
4/ These parts may be dose rate sensitive in a space environment and may demonstrate enhanced low dose rate effects.
Radiation end point limits for the noted parameters are guaranteed only for the conditions as specified in MIL-STD-883,
method 1019, condition A.
5/ For device type 03, radiation end point limits for the noted parameters are guaranteed for the conditions specified in
MIL-STD-883, test method 1019, condition D.
SIZE
STANDARD
5962-94680
A
MICROCIRCUIT DRAWING
DLA LAND AND MARITIME
REVISION LEVEL
E
SHEET
COLUMBUS, OHIO 43218-3990
3
DSCC FORM 2234
APR 97
ADI [ ADI ]
