ACT8846
Rev 4, 25-May-16
LOW-NOISE LDO ELECTRICAL CHARACTERISTICS
(VINL1 = VINL2 = 3.6V, COUT5 = COUT6 = COUT7 = COUT8 = COUT9 = 2.2µF, TA = 25°C, unless otherwise specified.)
PARAMETER
TEST CONDITIONS
MIN
2.5
-1
TYP
MAX
5.5
1
UNIT
V
Operating Voltage Range
VOUT ≥ 1.0V, IOUT = 10mA
OUT < 1.0V, IOUT = 10mA
VNOM
%
Output Voltage Accuracy
V
-10
10
mV
Line Regulation
Load Regulation
VINL = Max (VOUT + 0.5V, 3.6V) to 5.5V
IOUT = 1mA to IMAX
0.5
0.1
75
65
25
0
mV
V/A
f = 1kHz, IOUT = 20mA, VOUT = 1.2V
f = 10kHz, IOUT = 20mA, VOUT = 1.2V
Regulator Enabled
Power Supply Rejection Ratio
Supply Current per Output
dB
µA
Regulator Disabled
2
Soft-Start Period
VOUT = 3.0V
VOUT Rising
VOUT Falling
140
92
3.5
µs
%
%
Power Good Threshold
Power Good Hysteresis
IOUT = 20mA, f = 10Hz to 100kHz, VOUT
1.2V
=
Output Noise
30
µVRMS
Discharge Resistance
LDO Disabled, DIS[ ] = 1
1.5
kꢀ
LDO rated at 150mA (REG5 & REG6)
Dropout Voltage
Maximum Output Current
Current Limit
IOUT = 80mA, VOUT > 3.1V
140
280
280
mV
mA
mA
150
180
VOUT = 95% of regulation voltage
Recommend Output Capacitor
2.2
µF
LDO rated at 350mA (REG7, REG8 & REG9)
Dropout Voltage
IOUT = 160mA, VOUT > 3.1V
140
mV
mA
mA
µF
Maximum Output Current
Current Limit
350
400
VOUT = 95% of regulation voltage
Recommend Output Capacitor
2.2
: VNOM refers to the nominal output voltage level for VOUT as defined by the Ordering Information section.
: IMAX Maximum Output Current.
: Dropout Voltage is defined as the differential voltage between input and output when the output voltage drops 100mV below the
regulation voltage (for 3.1V output voltage or higher).
: LDO current limit is defined as the output current at which the output voltage drops to 95% of the respective regulation voltage.
Under heavy overload conditions the output current limit folds back by 50% (typ.)
Innovative PowerTM
- 19 -
www.active-semi.com
ActivePMUTM is a trademark of Active-Semi.
I2CTM is a trademark of NXP.
Copyright © 2016 Active-Semi, Inc.