I Cautions and Warnings:
The following conditions apply to all goods within the product series of WE-SECF
of Würth Elektronik eiSos GmbH & Co. KG:
General:
All recommendations according to the general technical specifications of the data sheet have to be complied with.
The responsibility for the applicability of customer specific products and use in a particular customer design is always within the authority of
the customer. All technical specifications for standard products do also apply for customer specific products.
Product specific:
Follow all instructions mentioned in the datasheet, especially:
•The solder profile has to be complied with according to the technical reflow soldering specification, otherwise no warranty will be sustai-
ned.
• To avoid contact finger misplacement and the coming off the soldering joints use maximum adjusted force at the Pick- and Place machi-
ne that does not exceed the recommended compression rate (of the contact fingers).
•The soldering joints must be kept clean, dry and grease free. The contact finger should be placed onto the solder pad of the printed circuit
board in a way that no tin- solder is able to come into the undermost or the first elastic bending of the contact fingers so that the bending
will not be affected.
•The contact finger shall not exceed the recommended compression rate. If recommended compression rate is exceeded there is a risk
that the spring will not be able to push back into the initial state.
•Do not bend the contact finger into the opposite position, as the material will overstretch and possibly break.
•Violation of the technical product specifications will result in the loss of warranty.
DESCRIPTION
WE-SECF SMD EMI Contact Finger
Würth Elektronik eiSos GmbH & Co. KG
EMC & Inductive Solutions
Max-Eyth-Str. 1
Order.- No.
74638 Waldenburg
Germany
Tel. +49 (0) 79 42 945 - 0
www.we-online.com
eiSos@we-online.com
SIZE
A4
331221602040
Size: 2240
1.0
2012-10-30
DATE
SSt
BY
WJ
REV
CHECKED
This electronic component has been designed and developed for usage in general electronic equipment only. This product is not authorized for use in equipment where a higher safety standard and reliability standard is especially required or where a failure of the product is reasonably expected to cause severe personal injury or death, unless the parties have executed an agreement specifically governing such use.
Moreover Würth Elektronik eiSos GmbH & Co KG products are neither designed nor intended for use in areas such as military, aerospace, aviation, nuclear control, submarine, transportation (automotive control, train control, ship control), transportation signal, disaster prevention, medical, public information network etc.. Würth Elektronik eiSos GmbH & Co KG must be informed about the intent of such usage before
the design-in stage. In addition, sufficient reliability evaluation checks for safety must be performed on every electronic component which is used in electrical circuits that require high safety and reliability functions or performance.
WURTH [ WURTH ELEKTRONIK GMBH & CO. KG, GERMANY. ]
