TS3003
PIN FUNCTIONS
PIN
NAME
FUNCTION
Fixed Frequency Output. A push-pull output stage with an
output resistance of 160Ω. FOUT pin swings from GND to
VDD. For lowest power operation, capacitance loads should
be minimized and resistive loads should be maximized.
Non-Connect.
1
FOUT
NC
2,3,
Pulse-width Modulated Output. A push-pull output stage with
an output resistance of 160Ω, the PWMOUT pin is wired anti-
phase with respect to FOUT and swings from GND to VDD.
For lowest power operation, capacitance loads should be
minimized and resistive loads should be maximized.
PWM Output Pulse Control Pin. Applying a voltage between
GND and VRSET will reduce the duty cycle of the PWMOUT
5
PWMOUT
6
PWM_CNTRL output that is set by the capacitor connected to the CPWM
pin. Connect PWM_CNTRL to VDD for fixed PWMOUT output
pulse time (determined only by capacitor at CPWM).
Ground. Connect this pin to the system’s analog ground
plane.
4,7
GND
PWMOUT Pulse Width Programming Capacitance Input. A
target capacitance connected from this pin to GND sets the
duty cycle of the PMW output. Minimize any stray capacitance
on this pin. The voltage on this pin will swing from GND to
VRSET. Connect CPWM to VDD to disable PWM function
(saves PWM current).
Power Supply Voltage Input. The supply voltage range is
1.55V ≤ VDD ≤ 5.25V. Bypass this pin with a 0.1uF ceramic
coupling capacitor in close proximity to the TS3003.
FOUT Programming Resistor Input. A 4.32MOhm resistor
connected from this pin to ground sets the T3003’s internal
oscillator’s output period to 40µs (25KHz). For optimal
performance, the composition of the RSET resistor shall be
consistent with a tolerance of 1% or lower. The RSET pin
voltage is approximately 0.3V.
8
9
CPWM
VDD
10
RSET
Page 6
TS3003DS r1p0
RTFDS
TOUCHSTONE [ TOUCHSTONE SEMICONDUCTOR INC ]
