PRECISION ANALOG FRONT ENDS
TC500
TC500A
TC510
1
2
3
4
5
6
7
8
TC514
Theinternalcomparatordelayis2µsec,typically.Figure
5 shows the comparator output for large positive and nega-
tive signal inputs. For signal inputs at or near zero volts,
however, the integrator swing is very small. If common-
mode noise is present, the comparator can switch several
times during the beginning of the signal-integrate period. To
ensure that the polarity reading is correct, the comparator
output should be read and stored at the end of the signal
integrate phase.
The comparator output is undefined during the Auto-
Zero Phase and is used to time the Integrator Output Zero
phase.(SeeIntegratorOutputZeroPhaseofSystemTiming
section).
Comparator Output
By monitoring the comparator output during the fixed
signal integrate time, the input signal polarity can be deter-
mined by the microprocessor controlling the conversion.
ThecomparatoroutputisHIGHforpositivesignalsandLOW
for negative signals during the signal-integrate phase (see
timing diagram).
Duringthereferencedeintegratephase,thecomparator
output will make a HIGH-to-LOW transition as the integrator
outputrampcrosseszero.Thetransitionisusedtosignalthe
processor that the conversion is complete.
SIGNAL
INTEGRATE
REFERENCE
SIGNAL
REFERENCE
DEINTEGRATE
INTEGRATE
DEINTEGRATE
INTEGRATOR
OUTPUT
ZERO
CROSSING
INTEGRATOR
OUTPUT
ZERO
CROSSING
COMPARATOR
OUTPUT
COMPARATOR
OUTPUT
A. Positive Input Signal
B. Negative Input Signal
Figure 5. Comparator Output
TELCOM SEMICONDUCTOR, INC.
3-27
TELCOM [ TELCOM SEMICONDUCTOR, INC ]
