CAS2/150MHz HSDRAM
64MB, 128MB DIMM
Preliminary Data Sheet
AC Characteristics (TA = 0°C to 70°C)
1. An initial pause of 200µs is required after power-up, then a Precharge All Banks command must be given followed by a minimum
of eight Auto (CBR) Refresh cycles before the Mode Register Set operation can begin.
2. AC timing tests have VIL = 0.8V and VIH = 2.0V with the timing referenced to the VTT = 1.4V crossover point.
VTT
tT
VIH
VTT
VIL
Clock
RT = 50 ohm
tSETUP tHOLD
Z0 = 50 ohm
Output
Input
CLOAD = 50pF
tOH
tAC
tLZ
VTT
Output
AC Output Load Circuit
3. The transition time is measured between VIH and VIL (or between VIH and VIL).
4. AC measurements assume tT = 1ns.
5. In addition to meeting the transition rate specification, the clock and CKE must transition VIH and VIL (or between VIH and VIL) in
a monotonic manner.
Enhanced Memory Systems Inc., 1850 Ramtron Dr., Colo Spgs, CO 80921
PHONE: (800) 545-DRAM; FAX: (719) 488-9095; http://www.edram.com
2000 Enhanced Memory Systems. All rights reserved.
The information contained herein is subject to change without notice.
Revision 1.0
Page 7 of 12
RAMTRON [ RAMTRON INTERNATIONAL CORPORATION ]
