Pomona®
Model 3600 & Assembly Instructions
Triaxial Cable Plug
Caution: Do Not Over Heat!
FIGURE #5
L. Slide Teflon contact sleeve over center contact.
M. Slide outer finger contact over Teflon contact sleeve.
N. Wrap blue wire around outer finger as shown and solder.
FIGURE #6
O. Slide clamp gasket, washer and clamp nut forward until gasket seats on the end of the braid clamp.
P. Slide outer Teflon sleeve over the outer finger contact.
FIGURE #7
Q. Slide plug body over the entire assembly and tighten clamp nut 35 to 40 inch-pounds.
L. Slide Teflon contact sleeve over center contact.
M. Slide outer finger contact over Teflon contact sleeve.
N. Wrap blue wire around outer finger as shown and solder.
All dimensions are in inches. Tolerances (except noted): .xx = ±.02” (,51 mm), .xxx = ± .005” (,127 mm).
All specifications are to the latest revisions. Specifications are subject to change without notice.
Registered trademarks are the property of their respective companies.
Made in USA
6/9/99
PomonaACCESS 90100 (800) 444-6785 or (425) 446-6010
More drawings available at www.pomonaelectronics.com
Sales: 800-490-2361 Fax: 888-403-3360
Technical Assistance: 800-241-2060
SY/EH/LS
S:\Engineering\Release\DataSheets\FlukeDataSheet\d_AI_3600_1_01.doc
Page 3 of 3