Pomona®
Model 3600 & Assembly Instructions
Triaxial Cable Plug
FIGURE #1
A. Cut cable.
B. Slide clamp nut, flat washer and clamp gasket over cable.
C. Strip jacket.
FIGURE #2
D. Fold back braid and trim cable filler.
E. Slide braid clamp over braid so that its inner shoulder butts against cable jacket. Fan out braid wires, fold back
over braid clamp, trim off excess braid as shown.
F. Cut conductors to dimensions shown.
FIGURE #3
G. Slide retainer over both conductors and press against braid clamp.
H. Strip blue (or equivalent) wire as shown.
I. Slide Teflon bushing over both conductors and press against retainer
J. Strip white wire to dimensions shown.
FIGURE #4
K. Place center contact sleeve over white conductor wire and solder, verify all strains go into the contact.
All dimensions are in inches. Tolerances (except noted): .xx = ±.02” (,51 mm), .xxx = ± .005” (,127 mm).
All specifications are to the latest revisions. Specifications are subject to change without notice.
Registered trademarks are the property of their respective companies.
Made in USA
6/9/99
PomonaACCESS 90100 (800) 444-6785 or (425) 446-6010
Sales: 800-490-2361 Fax: 888-403-3360
Technical Assistance: 800-241-2060
SY/EH/LS
More drawings available at www.pomonaelectronics.com
S:\Engineering\Release\DataSheets\FlukeDataSheet\d_AI_3600_1_01.doc
Page 2 of 3