EUA6210
Absolute Maximum Ratings
▓
▓
▓
▓
▓
▓
▓
▓
Supply voltage, ------------------------------------------------------------------------------------------------
6V
Input voltage ----------------------------------------------------------------------------------- -0.3 V to VDD +0.3V
Storage temperature --------------------------------------------------------------------------------- -65°C to 150°C
Power Dissipation ----------------------------------------------------------------------------------- Internally Limited
ESD Susceptibility Pin6 --------------------------------------------------------------------------------------
ESD Susceptibility for other Pins ---------------------------------------------------------------------------
Junction Temperature --------------------------------------------------------------------------------------- 150°C
Thermal Resistance
8kV
2kV
θJC (MSOP) ----------------------------------------------------------------------------------------------- 56°C/W
θJA (MSOP) ----------------------------------------------------------------------------------------------- 160°C/W
Electrical Characteristics VDD = 3.3V
The following specifications apply for VDD=3.3V, AV=1, and 32Ω load unless otherwise specified. Limits apply to
TA=25℃.
EUA6210
Typ
(Note1)
Symbol
Parameter
Conditions
Unit
Min
Max.
IDD
ISD
Quiescent Power Supply Current
Shutdown Current
VIN=0V, 32Ω load
4.1
0.1
4
6
mA
µA
VSHUTDOWN=GND
1.0
30
VOS Output Offset Voltage
mV
THD=1%(max); f=1kHz,
30
35
32Ω load
PO
Output Power
mW
THD=1%(max); f=1kHz,
67
16Ω load
THD+N Total Harmonic Distortion + Noise
PSRR Power Supply Rejection Ratio
PO=30mWrms; f=1kHz
0.2
%
Vripple=200mVp-p sinewave
Input Terminated with 10 ohms
to ground
59(f=217Hz)
48(f=1kHz)
dB
VIH
VIL
Shutdown Input Voltage High
Shutdown Input Voltage Low
1.5
V
V
0.4
Note 1: Typicals are measured at 25˚C and represent the parametric norm.
Note 2: Datasheet min/max specification limits are guaranteed by design, test, or statistical analysis.
Note 3: If the product is in shutdown mode and VDD exceeds 6V (to a max of 8V VDD) then most of the excess current will flow
If the source impedance limits the current to a max of 10ma then the part will be protected. If the
through the ESD protection circuits.
part is enabled when VDD is above 6V circuit performance will be
curtailed or the part may be permanently damaged.
DS6210 Ver1.1 Aug. 2007
4
EUTECH [ EUTECH MICROELECTRONICS INC ]
